Advertisement
Quick Links
INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
(EXP-EMG-EXT-42W SERIES COMPACT FLUORESCENT EMERGENCY
FACTORY SEALED LIGHTING FIXTURES)
EXP-EMG-EXT-42W COMPACT FLUORESCENT
EMERGENCY FACTORY SEALED LIGHTING
FIXTURES
CAUTION:
death and property damage. Do not attempt installation until you are familiar with the following procedures. All
installation must comply with the applicable Electrical Code.
Make sure that the circuit is de-energized before starting installation or maintenance.
Verify that the installation is grounded. Failure to ground will create electrical shock hazards, which can cause
serious injury and or death.
Technical information, advice and recommendations contained in these documents is based upon information
that Larson Electronics believes to be reliable. All the information and advice contained in these documents is
intended for use only by persons having been trained and possessing the requisite skill and know-how and to
be used by such persons only at their own discretion and risk. The nature of these instructions is informative
only and does not cover all of the details, variations or combinations in which this equipment may be used, its
storage, delivery, installation, check out, safe operation and maintenance. Since conditions of use of the
product are outside of the care, custody and control of Larson Electronics, the purchaser should determine the
suitability of the product for his intended use, and assumes all risk and liability whatsoever in connection
therewith.
Page 1 of 5
Advertisement
Summary of Contents for LARSON EXP-EMG-EXT-42W SERIES
- Page 1 Technical information, advice and recommendations contained in these documents is based upon information that Larson Electronics believes to be reliable. All the information and advice contained in these documents is intended for use only by persons having been trained and possessing the requisite skill and know-how and to be used by such persons only at their own discretion and risk.
- Page 2 1. IMPORTANT SAFEGUARDS – READ AND FOLLOW ALL SAFETY INSTRUCTIONS. OPERATING Remove globe assembly, unpack bulb and insert into socket. See installation instruction sections 4 & 5 for removal of globe assembly. NOTE: Read this sheet carefully before beginning installation. •...
- Page 3 Following steps required for installation - 1. Install unit’s mounting accessory per instructions supplied with the mount. 2. Install unit’s pushbutton test station (purchased separately) per instructions supplied with the to provide a method of disconnection the supply source from the unit. An example of how this can be completed is shown in Fig.1 for typical installation.
- Page 4 TYPICAL TEST INSTALLATION FIG.3 3. MAINTENANCE As routine maintenance, this emergency ensure it is working. The following schedule is recommended. SEE REVERSE FOR 1. Visually inspect the charging indicator light TEST & MAINTENANCE RECORDS monthly. It must be illuminated. 2. Test operation of the circuit at 30 day intervals CHART for a minimum of 30 seconds.
- Page 5 TEST & MAINTENANCE RECORDS Unit Location and/or Number ________________________________________________________ TEST DURATION MAINTENANCE DATE COMMENTS PERFORMED 30 min. 1 ½ hr. SAVE ALL INSTRUCTIONS Page 5 of 5...