Subscribe to Our Youtube Channel
Summary of Contents for General DataComm PacketMate 1000
- Page 1 Version: 3077 Copyright 2007-2010 ImageStream Internet Solutions, Inc., All rights Reserved.
- Page 3 Table of Contents Router Manuals/001 ............................1 PacketMate 1000 Router...........................3 Preface ..............................3 Copyright ............................3 Trademarks............................3 Scope of this Manual........................3 Manual Organization........................3 Safety Information ..........................4 Service Support and Training......................5 Chapter 1: Introduction and Specifications .....................6 Overview............................6 Specifications...........................7 Chapter 2: Installation and Setup......................8 Overview............................8...
-
Page 5: Router Manuals/001
Router Manuals/001 Router Manuals/001... - Page 6 Router Manuals/001...
-
Page 7: Preface
Scope of this Manual This manual describes how to install and operate the PacketMate 1000 Router. The information contained in this manual has been carefully checked and is believed to be entirely reliable. However, as General DataComm improves the reliability, function, and design of their products, it is possible that information may not be current. -
Page 8: Safety Information
Safety Information This manual should be read in its entirety and all procedures completely understood before installing or operating the unit. The notes that appear throughout this manual must be read prior to any installation or operating procedure. Examples of notes used in this manual are shown below. Indicates a note. -
Page 9: Service Support And Training
Never use a conductive tool, like a screwdriver or a paper clip, to set switches. Service Support and Training General DataComm offers two comprehensive customer support organizations dedicated to pre-and post-sale support services and training for GDC products. Corporate Client Services and Factory-Direct Support &... -
Page 10: Chapter 1: Introduction And Specifications
Chapter 1: Introduction and Specifications Overview The PacketMate 1000 Router is a low-cost routers that provide a lightweight aluminum chassis, 266 MHz CPU, 128 MB RAM, two on-board 10/100 ethernet ports, two Mini PCI slots, one USB bus with two internal ports, flash storage, and no cooling fans. -
Page 11: Specifications
Specifications Hardware Chassis: Lightweight Aluminum set-top Processor: 266 MHz AMD SC1100 Memory: 128 MB SDRAM Storage: Compact flash Network Ports: (2) P10/100 Ethernet Management Port: Serial console Expansion Interface: (2) Mini PCI Type III slots (1) USB 1.1 bus with two ports Power Supply Design: External AC/DC power supply AC Mains Voltage: 100 to 240 VAC... -
Page 12: Chapter 2: Installation And Setup
Installation Procedures Unpacking The Router This section describes the installation of the PacketMate 1000 Router and it?s standard equipment. It does not describe the configuration or other details of specific plug-in product cards UAS family products that it houses; for that information, refer to Related Publications on page ii. - Page 13 0.25V rms. To connect the unit to power, perform the following steps: The PacketMate 1000 comes with a switching power supply which converts the AC supply to a 5 VDC supply.
-
Page 14: Router Connections
3. Advanced 4. Router software management 5. Backup/Restore 6. halt/reboot 0. Log off Your first step should be to configure the global configuration settings on the router, described in Chapter 4, "Configuring Global Settings: the AAA and Global Configuration Menus" of the Router Manual located at http://wiki.gdc.com. -
Page 15: Chapter 3: Operations Information
ACT Status Description LNK Status Description Orange 10/100 LAN Yellow Linked Green GbE LAN Unlinked Connections using rear panel Ethernet ports: Connect the RJ-45 patch cable to the PacketMate?s Ethernet port. Connect the opposite end of the patch cable to another network device (router, switch, server, computer, etc.) through its Ethernet port. -
Page 16: Cpu Location
CPU Location Open the Chassis:... -
Page 17: Flash Storage Location
Flash Storage Location CPU Location... -
Page 18: Software
General DataComm, Inc. The information in this document is subject to change without notice. General DataComm assumes no responsibility for any damages arising from the use of this document, including but not limited to, lost revenue, lost data, claims by third parties, or other damages. -
Page 19: Trademarks
Trademarks All brand or product names are trademarks or registered trademarks of their respective companies or organizations. Related Publications A listing of related user manuals is provided below. In addition to the hardware and software manuals, always read the software System Release Notes supplied with your product. Decription Partnumber Trademarks... - Page 20 Related Publications...
Need help?
Do you have a question about the PacketMate 1000 and is the answer not in the manual?
Questions and answers