Stoelting E111I Operator's Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

E111/F111 IntelliTec Models

OPERATORS MANUAL

Manual No. 513532-5

Rev.1

Table of Contents

Need help?

Do you have a question about the E111I and is the answer not in the manual?

Questions and answers

Summary of Contents for Stoelting E111I

Page 1 E111/F111 IntelliTec Models OPERATORS MANUAL Manual No. 513532-5 Rev.1...
Page 3 If problems develop or questions arise in connection with installation, operation, or servicing of the freezer, contact the company at the following location: STOELTING 800-558-5807 502 Hwy. 67 Kiel, WI 53042 Fax: 920-894-7029 © 2013 Stoelting, LLC, All Rights Reserved...
Page 4 CAUTION If you need to replace a part, use genuine Stoelting The signal word “CAUTION” indicates a potentially parts with the correct part number or an equivalent hazardous situation, which, if not avoided, may result part.
Page 5 TABLE OF CONTENTS Section Description Page Introduction Description ....................1 Speciﬁ cations ..................... 1 Installation Instructions Safety Precautions ..................3 Shipment and Transit .................. 3 Machine Installation ..................3 Initial Set-Up and Operation Operator’s Safety Precautions ..............5 Operating Controls and Indicators .............. 5 Important Information Regarding Cleaning and Sanitizing ......
Page 7: Description
SECTION 1 INTRODUCTION 1.1 DESCRIPTION The Stoelting E111 and F111I counter machines are grav- ity fed. The machines are equipped with fully automatic controls to provide a uniform product. They are designed to operate with almost any type of commercial soft serve or non-dairy mixes available, including: ice milk, ice cream, yogurt, and frozen dietary desserts.
Page 8 Air cooled units require 3” (7,6 cm) air space on both sides Water cooled units require 3/8” N.P.T. Plumbing Fittings water and drain ﬁ ttings. Hopper Volume 3 gallon (11,35 liters) Freezing Cylinder 0.65 gallon (2,46 liters) 0.85 gallon (3,22 liters) Volume Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 9: Safety Precautions
10 days and request inspection. The customer must place claim for damages and/or shortages Place the Main Freezer Power Off/On switch in in shipment with the carrier. Stoelting, Inc. cannot make the OFF position. any claims against the carrier.
Page 10 Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 11: Operator's Safety Precautions
Never operate the machine if unusual or excessive noise or vibration occurs. Dispense Rate Adjustor Main Power OFF-ON IntelliTec Control (See Figure 3-2) Figure 3-1 E111 & F111 Controls Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 12 The message will display when there is approximately one gallon of mix left in the hopper. Up Arrow Button When the MIX LOW message is displayed, reﬁ ll hopper immediately. Figure 3-2 IntelliTec Control Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 13: Important Information Regarding Cleaning And Sanitizing
(milkstone). Thorough cleaning PRODUCT SAFETY – Strong acids are dangerous procedures that involve milkstone removal are critical for chemicals. Carefully follow safety instructions operators of frozen dessert machines. provided with delimer products. Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 14 Hazardous Moving Parts Revolving auger shaft can grab and cause injury. Place the Main Freezer Power OFF-ON switch in the OFF position before disassembling for cleaning or servicing. Figure 3-4 Removing Auger Support Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 15: Disassembly Of Machine Parts
Remove the drip tray by pulling from the front panel. Clean and replace the drip tray. Figure 3-6 Removing O-Ring Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 16: Assembling Machine
Hand tighten circular knobs evenly. Figure 3-7 Auger Springs Install the two plastic ﬂ ights onto rear of the auger and insert part way into machine barrel. Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 17: Sanitizing
Mix the sanitizer in quantities of no less than 2 3.10 INITIAL FREEZE DOWN AND OPERATION gallons of 90° to 110°F (32° to 43°C) water. Any Every Stoelting soft serve machine needs to be set on site. sanitizer must be used only in accordance with the manufacturer’s instructions.
Page 18: Normal Freeze Down And Operation
When a digit reaches 9, pressing the up arrow spigot to allow the mix to ﬂ ush out about 8 ounces () button again will change the value to 0. (0.23 liters) of sanitizing solution and liquid mix. Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 19: Mix Information
When checking the temperature, stir the thermometer in the frozen product to get an accurate reading. Old mix, or mix that has been stored at too high a tempera- ture, can result in a ﬁ nished product that is unsatisfactory. Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 20 Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 21: Machine Adjustment
When all readings have been obtained, press the up arrow button () from ExitMenu to return to the current mode display. Figure 4-1 Membrane Switch Owner’s Manual #513632-5 Rev.1 E111I/F111I Model Machines...
Page 22 Owner’s Manual #513632-5 Rev.1 E111I/F111I Model Machines...
Page 23: Readings (Service Personnel Only)
Door safety switch triggered °F and amps High pressure cutout The suction line temperature on the freezing cylinder and the drive motor amps are available on the same screen to assist with setup and troubleshooting. Owner’s Manual #513632-5 Rev.1 E111I/F111I Model Machines...
Page 24: Adjustments (Service Personnel Only)
Increasing this value will increase the length of the consistency. To properly set the CutOut value, freezing cycle during “Standby Mode” and result refer to Section 3. in a decrease of average product temperature in the barrel. Owner’s Manual #513632-5 Rev.1 E111I/F111I Model Machines...
Page 25: Drive Belt Tension Adjustment
Hpr On (sec) If the temperature sensor in the hopper fails, this setting determines the length of the hopper refrigeration cycle. This setting is only available on the left control.. Figure 4-3 Belt Tension Adjustment Owner’s Manual #513632-5 Rev.1 E111I/F111I Model Machines...
Page 26: Condenser Cleaning
Check for any unusual noise or condition and repair immediately. Inspect for worn or broken parts and replace as necessary. Check the wear line on the auger ﬂ ights and replace as needed. Owner’s Manual #513632-5 Rev.1 E111I/F111I Model Machines...
Page 27: Error Codes
Cylinder Off-On switch must be placed in the Off position If the error persists after attempting to clear it, and back in the On position before the affected side of contact your Authorized Stoelting Distributor for the machine will return to normal operation. further assistance.
Page 28 Off and back On. If the error persists, contact will immediately end. This error usually occurs your Authorized Stoelting Distributor for further when the machine continues to run in a low mix assistance.
Page 29: Troubleshooting - Machine
3 Chipped or worn spigot o-rings. 3 Replace o-rings. Front door leaks. 4 O-rings or spigot installed wrong. 4 Remove spigot and check o-ring. 5 Inner spigot hole in front door nicked 5 Replace front door. or scratched. Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 30 Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 31: Decals And Lubrication
Decal - Attention Heat Sensitive 324612 Decal - Control 324686 Decal - Danger Automatic Start 324803 Decal - Domed Stoelting Logo (Large) (Header Panel) 324804 Decal - Domed Stoelting Swirl (Header Panel) 324806 Decal - Domed A & W Logo (Header Panel) 324825...
Page 32: Auger Shaft And Faceplate Parts
O-Ring - Front Door - Red 666786 Seal - Rear Auger - Black 694255 Spring - Auger Flight 2177698 Door w/Pins 2187812 Spigot Body 3170644 Support - Front Auger 4157952 Auger Shaft 4157968 Auger Shaft Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 33: Hopper Covers And Trays
O-Ring - Mix Inlet - Black (5 Pack) 744283-SV Tray - Drip 744284 Insert - Drip Tray 744606 Tray - Drain (Black Plastic) 2149238 Mix Inlet Assembly - 3/16” Hole - Standard Length (3A) Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 34 Owner’s Manual #513532-5 Rev.1 E111I/F111I Model Machines...
Page 35 Stoelting, LLC warrants to the first user (the “Buyer”) that the freezer cylinders, hoppers, compressors, drive motors, speed reducers, augers and auger flights of Stoelting soft serve / shake freezers will be free from defects in materials and workmanship under normal use and proper maintenance appearing within five (5) years, and that...

This manual is also suitable for:

F111i