Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
In case of trouble with the unit, please look through problems below and see if you can solve
them yourself before calling your dealer.
Problem
Power does not come
on when the power
switch is pressed.
No sound comes out
of the speakers.
The sound is noisy.
The unit does not act
as expected, or
respond.
Cannot listen to any
station, or signal
appears weak.
The sound is
distorted.
CD stops immediately
after starting, or unit
pauses or stops
during play.
No sound.
Specific CD is noisy, or
playback stops or
skips.
Cause
• Unit is unplugged.
• The external speakers are
disconnected.
• The volume is turned down
(to MIN).
• The input selector does not
match the playback source.
• The unit is too close to a TV
set or another similar
appliance.
• External factors such as ESD
(Electro‐static discharge)
affect the unit.
• The station is not tuned‐in
properly.
• A TV set is being used
nearby and is interfering with
the radio reception.
• The antenna is not
positioned properly.
• The CD is inserted upside
down.
• The CD is dusty or dirty or
there is condensation on the
CD.
• The CD player is paused.
• The CD is scratched,
damaged or warped.
• The disc is very dirty.
Solution
• Connect the unit to the AC
power supply.
• Connect the external
speakers.
• Adjust the volume.
• Re‐select the desired input
source.
• Turn off the TV or other
appliance, and relocate the
unit.
• Remove the power cord and
all power supply devices.
Then re‐plug the unit after
one minute.
• Properly tune‐in the desired
station.
• Turn‐off the interfering TV
set.
• Re‐position the antenna
until reception improves.
• Insert the CD with the
printed side right‐side up.
• Carefully clean and dry the
CD.
• Press the PLAY/PAUSE
button.
• The CD should be changed.
• Carefully clean the CD.
Advertisement
Table of Contents
