Advertisement
Available languages
Available languages
take
a seat
1. Plug it in
Plug the power cord into a grounded 120-volt power source.
2. Adjust the recline angle
Before adjusting the recline angle, be sure there is nothing located directly behind or beneath the chair.
Gently push down on the electric recline lever to recline, or pull up on the lever to adjust the angle forward.
Release the lever when you reach the desired angle. The chair automatically stops when you reach the
maximum recline or the full upright position. In the full upright position, the legrest automatically folds inward
for easy entrance and exit from the chair.
NOTE: Lean back against the backrest before reclining the chair.
3. Adjust the headrest
While seated, reach up with both hands and grasp both sides of
the headrest. You will feel the rigid frame beneath the soft head
pad. Grasping the rigid frame, tilt the headrest forward or back-
ward for maximum comfort. The headrest remains in this position
until you adjust it again.
When adjusting the footrest up and down, you may notice a slight bumping sensation.
This is caused by the footrest locking mechanism, and is perfectly normal.
humantouch.com
10
Using your Human Touch Perfect Chair
the chair to the desired position. The Perfect Chair cradles you in zero-
gravity comfort, with your feet above your heart—the ultimate neutral-
posture position for back and spine relief.
4. Getting out of the perfect chair
While seated, pull up gently on the electric recline lever until the
backrest automatically stops in a full upright position and the
footrest automatically stops in a vertical position (the backrest
stops before the footrest). Use the arms for support when getting
up from the chair.
CAUTION: Do not put any extra pressure on the footrest
while returning the chair to an upright position. Do not
push on the footrest, or lean against it.
Adjusting body pad thickness
1. To compress the body pad thickness, sit in the chair, lean
against the backrest, then push the ball valve on the back of
the body pad. When the pad reaches the desired thickness,
release the valve.
2. To reinflate the body pad, push the ball valve without
applying any pressure to the pad. When the
pad reaches the desired thickness, release the
valve. It takes approximately ten seconds for the
pad to reach its full thickness.
BODY PAD PERFORMANCE NOTES
• You must remove all body weight from the pad when reinflating it.
• If the pad has been compressed for a long period of time, it may take up to one minute to restore it to its full thickness.
• The colder the pad is, the longer it takes to react to form changes.
• Should the ball valve leak, push the black ball in and, with a cotton swab, apply a small amount of Vaseline inside the valve.
• Keep sharp objects away from the pad. The pad contains a precision air-tight bladder which that will not function properly
if punctured.
is easy. Just take a seat and adjust
Body pad
11
Advertisement
