Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Nke Watteco SMARTPLUG
- Page 1 SMARTPLUG UIDE...
- Page 2 Nke Watteco products are not designed, authorized or warranted to be suitable for use in life saving or life support devices or systems. Inclusion of Nke Watteco products in such applications is understood to be fully at the Customer's risk.
- Page 3 SmartPlug User Guide DOCUMENT HISTORY Date Revision Modification Description March 2016 First revision All Rights Reserved – nke Watteco® SmartPlug User Guide Page 3 of 12...
- Page 4 Configure a standard report on the Power Quality Cluster ..................10 5.1.3 Configure a batch report on the Simple Metering Like Cluster ................11 Appendix ........................... 12 SmartPlug FCC Label................................ 12 All Rights Reserved – nke Watteco® SmartPlug User Guide Page 4 of 12...
- Page 5 Networks” for the network layer in prerequisite for all generic information. TART The SmartPlug uses the main voltage as a power supply. In order to switch it on, plug it into a wall socket. The SmartPlug will automatically start. Here below can be seen illustrations of the SmartPlug in the Europe version and in the US version.
- Page 6 The SmartPlug remote is not waterproof. Thus, it has to be protected from the water splash and cannot be used in bathrooms. Once plugged, the SmartPlug led will flash green. As long as the SmartPlug is not paired with the LoRaWAN network, the led will flash (cf.
- Page 7 The direct application for the SmartPlug is to control electrical devices thanks to their electric supplies. Indeed the SmartPlug is plugged inside a wall socket. Then the device to control has to be plugged on the SmartPlug’s socket, as it can be seen on the picture here below.
- Page 8 Finally, the SmartPlug integrates as well the electronic necessary to measure and evaluate the quality of the electrical main where it is plugged to. In the array here below, are listed the available indicators provided by the SmartPlug to evaluate the quality of the main. These measures are located inside the Power Quality cluster (cf.
- Page 9 (7 to 8 second, until the orange led blink), the orange led will blink 3 times and a “Reset Factory” is done. To complete the “Reset Factory” the device needs to be reboot (unplug and plug the SmartPlug will do a correct reboot).
- Page 10 5.1 E XAMPLES Herebelow are some examples of sending an On/Off order to the SmartPlug or configuring a report or a batch on either the “Simple Metering” Cluster or on the “Power Quality” cluster. If you want more informations about the applicative layer, please refer to the “LoRaWAN Sensors Application Layer Description” document.
- Page 11 For both of the measure, the maximum field has to be 0x80B4 to have a report at least every 3 hours and the minimum field has to be 0x800A to have a minimal timing of 10 min between two reports. Applicative payload is: 110600522D000000800A80B400000A0000010103800A80B40064000109 All Rights Reserved – nke Watteco® SmartPlug User Guide Page 11 of 12...
- Page 12 Caution: Changes or modifications not expressly approved by the party responsible for FCC compliance could void the user authority to operate the device. (Cf. FCC Part 15.21). All Rights Reserved – nke Watteco® SmartPlug User Guide Page 12 of 12...
Need help?
Do you have a question about the SMARTPLUG and is the answer not in the manual?
Questions and answers