Advertisement
Troubleshooting and maintenance
TROUBLES
POSSIBLE CAUSES
SAFETY FUSE IS NOT
ORANGE LED
INSTALLED
IS NOT
SOLAR PANEL IS
ILLUMINATED
NOT CONNECTED
WHEN SOLAR
CORRECTLY
PANEL IS
CONNECTED
SOLAR PANEL NOT
EXPOSED TO THE SUN
SAFETY FUSE IS NOT
INSTALLED
LED LIGHTS
WILL NOT
RED LED IS ON / POWER
OPERATE
PACK IS FLAT
LED LIGHTS
RED LED IS ON -
OPERATE FOR
POWER PACK IS LOW IN
A SHORT TIME
VOLTAGE
ONLY
SAFETY FUSE IS NOT
INSTALLED
POWER PACK
CHECK POWER PACK
WILL NOT
CONDITION
CHARGE
CHECK SOLAR PANEL
OUTPUT
SPECIFICATIONS
NORMAL VOLTAGE
MAX. CHARGING CURRENT/LOAD CURRENT
CURRENT NATURAL LOSS
STC Power
Operating Voltage (Vmp)
SOLAR MODULE
Operating Current (Imp)
Open Circuit Voltage (Voc)
Short Circuit Voltage (Ics)
Battery Type
BATTERY
Capacity
Light Source
Rate Power
DC LAMP
Rate Voltage
Rate Current
Luminosity
CHARGING TIME
Approx. 8 to 10 hours in full sunlight when the
(SOLAR)
battery is fully discharged
CHARGING TIME
Approx. 8 hours when the battery is fully discharged
(AC CHARGER)
OPERATING TIME 1 lamp
4 lamps
OPERATING TEMPERATURE RANGE
Please note: Specifications may change without notice
www.primusaustralia.com.au • Sales: 1300 555 197
PRI4826_Solar_Panel_manual.indd 4
Frequently asked questions
CORRECTIVE MEASURES
Q: Will direct shade affect the power output of the solar panel?
INSTALL FUSE
A: Yes, locate the panel in direct sunlight for maximum output.
Q: Will my solar panel work in cloudy conditions?
CONNECT TO POWER PACK
A: Yes, the solar panel will work in low light conditions however the
LOCATE IN DIRECT SUN
Q: Should I clean my solar panel?
LIGHT
A: Yes, removing dust, dirt, bird droppings, etc with warm soapy
INSTALL FUSE
CHECK CONNECTIONS
Q: How do I clean the power pack?
& SWITCHES ARE IN ON
A: Use a mix of warm soapy water, do not use bleach or harsh
POSITION
CHARGE POWER PACK
LOCATE SOLAR PANEL IN
Q: Can I replace the LED's?
DIRECT SUNLIGHT FOR
MINIMUM OF 8 HOURS
A: No, the LED light has a life expectance of 8,000 hours of
CHECK CONNECTIONS &
SWITCHES
Suggestions for safe and secure use
INSTALL FUSE
IF FAULTY - REPLACE
BATTERY
IF FAULTY - CONTACT
MANUFACTURER
•
•
•
12V
•
≤1A
≤5mA
5W
•
17V
0.29A
•
21.6V
0.34A
Maintenance Free
•
Lead - acid battery
12V/5.0AH
•
12 Super
•
Bright LED
0.6W
•
12V
50mA
50Lum
General Disclaimer
In no event shall the manufacturer be liable for any damage or personal
injury caused by non-compliance to the operating instructions and safety
66 Hours
suggestions in this brochure. The manufacturer will not bear any
16 Hours
responsibility for misuse, damage, injury, incorrect installation and/or
system design as such.
-10~60°C
(-40~122°F)
power output will be reduced as there is less energy collected.
water will assist with the solar panels energy collecting
performance
cleaning chemicals and carefully wipe down all surfaces
avoiding water entering the power pack.
continuous operation.
Failure to follow these complete instructions and the
suggestions below may cause system damage and/
or personal Injury.
This controller is only designed for 12V solar charging.
The built-in electronic circuit protector keeps the controller away
from overcharging, overflowing, overloading and short-circuit.
Sealed, maintenance free VLRA batteries are highly
recommended.
The controller will heat up during use, place in a well-ventilated
location and avoid contact with the controller surface.
Keep the ventilation holes on the controller free of dust
and debris.
The battery may produce flammable gases, please keep
away from spark or open flame, ensure the battery is kept in
a well-ventilated location.
Fully charge the battery at least once a month.
Do not contact or short circuit the terminals or wires.
Please use insulated tools during operation, keep both hands
dry and do not stand on the wet ground.
Please follow the security recommendations from the battery
manufacturer. Contact the distributor or the installation
personnel if there is any doubt.
14/12/11 3:58 PM
Advertisement
