Table of Contents
Advertisement
Safety, Care and Regulatory Information
Important safety information
Read and follow all instructions marked on the product and in the documentation before
you operate your system. Retain all safety and operating instructions for future use.
The product should be operated only from the type of power source indicated on
the rating label.
If your computer has a voltage selector switch, make sure that the switch is in the
proper position for your area. The voltage selector switch is set at the factory to the
correct voltage.
The plug-socket combination must be accessible at all times because it serves as
the main disconnecting device.
All product shipped with a three-wire electrical grounding-type plug only fits into a
grounding-type power outlet. This is a safety feature. The equipment grounding
should be in accordance with local and national electrical codes. The equipment
operates safely when it is used in accordance with its marked electrical ratings and
product usage instructions
Do not use this product near water or a heat source.
Set up the product on a stable work surface or so as to ensure stability of the
system.
Openings in the case are provided for ventilation. Do not block or cover these
openings. Make sure you provide adequate space around the system for ventilation
when you set up your work area. Never insert objects of any kind into the
ventilation openings.
To avoid electrical shock, always unplug all power cables and modem cables from
the wall outlets before removing covers.
Allow the product to cool before removing covers or touching internal components.
Precautions for Products With Laser Devices
Observe the following precautions for laser devices:
Do not open the CD-ROM drive, make adjustments, or perform procedures on a
laser device other than those specified in the product's documentation.
Only authorized service technicians should repair laser devices.
Precautions for Products With Modems, Telecommunications, or Local
Area Network Options
Observe the following guidelines when working with options:
Do not connect or use a modem or telephone during a lightning storm. There may
be a risk of electrical shock from lightning.
To reduce the risk of fire, use only No. 26 AWG or larger telecommunications line
cord.
Do not plug a modem or telephone cable into the network interface controller (NIC)
receptacle.
Disconnect the modem cable before opening a product enclosure, touching or
installing internal components, or touching an uninsulated modem cable or jack.
Do not use a telephone line to report a gas leak while you are in the vicinity of the
leak.
3
Advertisement
Table of Contents
