SISTEMATICA CONTROLLER 32 User And Maintenance Manual

Radio remote control 32 outputs

Advertisement

Quick Links

RADIO REMOTE CONTROL 32 OUTPUTS
This manual is an essential part of the device and it should be thoroughly kept for later consultation.
Carefully read the warnings contained in this manual, concerning safety and a proper preservation of the
product. These warnings are always to be carefully read before using the device. SISTEMATICA S.p.A.
declines all responsibility for any trouble arising from the non-compliance with these warnings.
DO NOT TRAVEL WITH THE DEVICE SWITCHED ON
CONNECT THE SYSTEM ONLY TO THE VEHICLE'S BATTERY
BEFORE CARRYING OUT ANY MECHANICAL MAINTENANCE OPERATION (WELDING) ON THE
VEHICLE, DISCONNECT THE BATTERY CLIPS.
AVOID ATTEMPTING TO REPAIR THE DEVICE BY YOURSELF. REPAIRS PERFORMED BY
UNSKILLED PEOPLE CAN CAUSE SERIOUS DAMAGES OR FAILURES. FOR ASSISTANCE,
APPLY TO YOUR LOCAL AUTHORIZED SERVICE CENTRE. USE ONLY ORIGINAL SPARE PARTS.
ALWAYS KEEP AT A SAFE DISTANCE FROM THE MOVING PARTS.
SISTEMATICA S.p.A.
SISTEMATICA S.p.A.
SISTEMATICA S.p.A.
SISTEMATICA S.p.A.
Via S. Pertini, 17 – 12030 MANTA (CN) ITALY Tel. +39 0175 255.711 r.a. – Fax +39 0175 255.715
http://www.sistematica.it
CONTROLLER 32
USER AND MAINTENANCE MANUAL

WARNINGS

e-mail:
info@sistematica.it
REV.1 1 1 1
REV.
REV.
REV.
01/03/2013

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CONTROLLER 32 and is the answer not in the manual?

Questions and answers

Summary of Contents for SISTEMATICA CONTROLLER 32

  • Page 1 Carefully read the warnings contained in this manual, concerning safety and a proper preservation of the product. These warnings are always to be carefully read before using the device. SISTEMATICA S.p.A. declines all responsibility for any trouble arising from the non-compliance with these warnings.
  • Page 2 Coding the system is an operation that is only necessary when the receiver has to be replaced or you want to use it with a different SISTEMATICA radio remote control from the one it is coupled with at the time of purchase.
  • Page 3 DRILLING TEMPLATE DIMENSION ANTENNA INSTALLATION The CONTROLLER 32 is provided with an external antenna (STUB) with relative gasket. It must be mounted on the SMA connectoron the back of the controller. For a correct installation procedure, perform the following steps: 1.
  • Page 4 CE MARK Declaration of conformity for Sistematica S.p.A. products can be required at: info@sistematica.it This product may be subjected to usage restriction. Please contact info@sistematica.it for any further questions. FCC STATEMENTS These devices complies with Part 15 of the FCC rules.

Table of Contents