KAM Systems i2 Series User Manual

Wireless Motion Sensor Package
Features
The Wireless Motion Sensor Package is a complete
solution that enables monitoring of a resident trying
to get out of bed or up off a chair. It can also monitor
a resident leaving or entering a bedroom. Each
receiver allows the addition of up to 10 wireless
accessories such as wrist alarms, neck pendants,
motion detectors etc.
The Wireless Motion Sensor can be placed on the
floor, bedside table or wall. The sensor emits an
invisible infrared 'curtain' from floor to ceiling.
When this 'curtain' is breached, it will send an alarm
activation wirelessly to the Receiver Unit, which in
turn will then activate the Call Point. The freedom of
being wireless allows the Motion Sensor to be placed
anywhere in the room. Coverage is no issue as it
will easily cover even the largest of bedrooms. The
Motion Sensor is operated by a 3V Long Life Lithium
Battery and will last at least 12 months. Spare
batteries can be ordered on Nursecall Shop.
Powered by KAM Systems Limited
Powered by KAM Systems Limited
User Guide User Guide
The Wireless Motion Sensor comes complete with
stand and blinding cover. This allows the sensor
to be placed anywhere in a room covering exits,
chairs/Beds. Located at the top of the sensor stand
is a mounting hole, this will allow the sensor to be
mounted to the wall.
After detection, the detector disarms itself to save
battery power. It rearms (reverts to its ready state)
If there is no subsequent detection throughout the
following 2-minute period.
When not in use the blinding cover will shield the
Wireless Motion Sensor from any activity thus
allowing for free movement within the room
without alarms being triggered.
www.nursecallshop.co.uk
www.nursecallshop.co.uk
Series Series
i
2 2
i