Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for auto maskin Marine Pro RP 410
- Page 1 Manual# 1100272 Quick Installation Guide RP 410 Remote Panel...
- Page 3 Table of Content Document Information ............2 Content ................4 Installation ................5 Unwrapping ............... 5 Panel Installation ............... 5 Network ................6 Power-On ................7 Factory Startup Wizard ............7 System Configuration ............8 Quick Installation Guide P a g e...
-
Page 4: Document Information
Quick Installation Guide Printed: January 2017 Revision: Copyrights and Trademarks Copyright © Auto-Maskin AS, 2017 Information given in this document may change without prior notice. This document should not be copied without written permission from Auto-Maskin. All trademarks acknowledged. P a g e... -
Page 5: Ordering Information
Ordering Information The following parts are available in the Marine Pro range Item Part # DCU 410 – Engine Control 1006450 DCU 408 – Engine Control 1006455 RIO 410 – I/O Expansion 1006453 RIO 425 – Generator Interface 1006409 SDU 410 – Safety Unit 1006451 RP 410 –... -
Page 6: Content
Note! Auto-Maskin continuously upgrades its products and reserves the right to make changes and improvements without prior notice. All information in this manual is based upon information at the time of printing. For updated information, please contact your local distributor. -
Page 7: Installation
Installation Unwrapping Make sure the unit is not damaged in transport, and that these parts are in the box: The RP 410 Remote Panel A bag of screws and nuts Panel Installation The RP 410 is intended as a remote command and monitoring panel, and as such can be installed in the engine control room or in the wheelhouse. -
Page 8: Network
CAT5 ethernet cable between a single DCU and the RP, using the ethernet ports on the two. Auto-Maskin recommend however, always installing an ethernet switch in-between the two for these reasons: Easy to connect a laptop to the ... -
Page 9: Power-On
Power-On Connect the 24V supply The supply is typically the ships redundant 24VDC supply. Unplug the wire terminal block, and connect the 24V supply wires as follows: 24V to terminal 1 0V to terminal 2 Attach the wire terminal block and watch as the RP 410 is booting for the first time. -
Page 10: System Configuration
System Configuration The RP will read the configuration from the DCU 410 (and DCU 408) unit(s) in the network, and all instruments and configurations in those units will appear on the RP 410. However, the RP 410 can be adjusted to suit special needs in the System Configuration section. -
Page 11: Change Password
Change password Once logged into the Administration section, make sure to change the password. Auto-Maskin suggest a company-based or per-person based password. Lost Password If the password is lost, please contact your distributor Encrypted who will be able to unlock the panel using the... - Page 12 P a g e | 10 Quick Installation Guide...
Need help?
Do you have a question about the Marine Pro RP 410 and is the answer not in the manual?
Questions and answers