Table of Contents
Advertisement
Quick Links
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1)This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT
SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE
EQUIPMENT.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
User's Manual
GFT-42E
1
Advertisement
Table of Contents
Summary of Contents for Fine Wave GFT-42E
- Page 1 User’s Manual GFT-42E This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 2 1. Summary This unit is a portable FM transmitter and is designed to minimize volume and weight by using the recent miniature parts. This unit is a multi-use device and is manufactured so that the consumer can use it for various purposes at desired position.
- Page 3 ⑩ Frequency used: 106.7, 106.9, 107.1, 107.5, 107.7, 107.9 (㎒) Support console for vehicle ① Size: 34.0mm × 27mm × 14.0mm ② Weight: 10g ③ Fixing method - Fixing of both vehicle and support console: Both sided tape - Fixing of both support console and transmitter: Magnet on support console and magnetic power of main body (battery + metal plate) 3.
- Page 4 Attached User’s Manual provided for sale. User’s Manual You can hear MP3 player or CD player by using a speaker via a FM radio in a vehicle or home. Thank you for purchasing a portable FM wireless transmitter made by our Seobong Electronics Co., Ltd. After purchasing product, be sure to read this User’s Manual before using it.
- Page 5 Before using product …… Where questions or failure occurs during use of product, Please call our A/S center (Main Office at Pusan) (Tel: 051-529-2711). Caution. - Contents of this manual may change without prior notice. - Operation of this unit is -10°C ~ 50°C and don’t leave it where temperature is too low or high for a long time.
-
Page 6: Caution For Safety
Cautions for Safety - Cautions for safety are classified into ‘Warning’ and ‘Caution’ and they has meaning as below: (/////) Warning Non-observance of instructions may cause death or serious injury. (/////) Caution Non-observance of instructions may cause insignificant injury or loss of property. - After reading User’s Manual, keep it where the user of product can easily find. -
Page 7: Caution In Use
Caution in use /// Caution - Don’t disclose the unit to direct sunlight. Don’t lay the unit near heater or hot place. - To remove dusts, don’t use a smooth cloth without using liquid solvent (thinner, benzene, etc) or wet rag, etc. - Don’t apply shock or fall the unit down. -
Page 8: About Method To Use Cell
About method to use cell 1. Pull and open the cell cover to the arrow direction. 2. Insert the cell after checking (+), (-) polarity and close the cover. Use ‘AAA’-type of the cell standard. - Refer to follows!!! If using the cell for a long time with it mounted on the unit, the cell may be naturally discharged. 3. -
Page 9: About Basic Method To Use This Unit
About basic method to use this unit - Use instructions will be basically provided on a portable MP3 player. - Products used with this unit are designed so that they can be connected with any device with earphone or headphone jack mounted such as portable CD player, cassette player. [To mount support console for vehicle] Firstly, mount support console for vehicle near the radio tuner of a car. - Page 10 3. Adjust the high frequency and low frequency conversion switch of this unit to High or Low. - This is to select frequency that music is mostly received, of FM radio frequency of a car and frequency of this unit. High = 107.5, 107.7, 107.9 (MHz) Low = 106.7, 106.9, 107.1 (MHz) 4.
-
Page 11: Checkpoints Before Requesting Service
Checkpoints before requesting service - Check following matters before requesting service and where same symptom continuously occurs in spite of it, call our service center. 1. Phenomena that the power on display lamp turns on weakly or sound is frequently interrupted occur. -
Page 12: Warranty Card (Warranty Regulations)
Warranty Card (Warranty Regulations) Purpose of this warranty represents our corporation’s promise to provide free of charge repair as described below. If failure occurs during the warranty period, refer to our service center or your purchasing agency accompanying with product and this warranty. If the purchase YY/MM/DD and trade name of sale agency are omitted, you cannot be entitled with warranty. -
Page 13: Warranty Card
<Instructions in post mail> Please be cautious of following matters in post mail. 1. Please send this warranty card together with product during the warranty period. 2. Wrap product with dumping materials and put it in a box to prevent damage during transportation. Post charges, packing expenses, etc for transportation must be borne by the customer.
Need help?
Do you have a question about the GFT-42E and is the answer not in the manual?
Questions and answers