Advertisement
Available languages
Available languages
***************************************************************************************************************************************************************
WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full
compliance with N.E.C. requirements. If there are any questions, contact a Qualified Electrical Contractor.
CAUTION - All glass is fragile, use care when handling Glass component(s) and or Lamp(s).
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and /or
other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
WARNING - the edge of the wall plate must be sealed to the wall with a permanent waterproof material (latex,sillcone,
urethane, etc.) to comply with U.L. requirements.
NOTE: For more product specifications and information see www.progresslighting.com
***************************************************************************************************************************************************************
A
2 X
C
ASSEMBLY STEPS:
ASSEMBLAGE ÉTAPES:
MONTAJE PASOS:
A, B, D
1. C
Assembly & Installation Instructions
CAUTION:
Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
D
B
(NOT FURNISHED)
(NON FOURNIE)
(NO INCLUIDA)
WHITE SUPPLY
WIRE
BLACK SUPPLY
WIRE
BARE, OR GREEN
GROUND WIRE
FROM SUPPLY
BARE, OR GREEN
GROUND WIRE
FROM SUPPLY
P6341
F
E
Turn the knob clockwise for maximum setting and
counter-clockwise for minimum setting.
D & F
The knobs have been preset at the factory but may
need to be adjusted to personal preference.
- " TIME " controls the length of time the light remains
- " SENS " controls the sensitivity to motion (approx
- " LUX " controls sensitivity to light. (approx light
WHITE OR IDENTIFIED
FIXTURE WIRE
UL LISTED
WIRE NUTS
• Power source:102 - 145VAC
PLAIN OR BLACK
• Rated load: 360W max (tungsten)
FIXTURE WIRE
• Rated load: 80W max (flourescent)
BARE, OR GREEN
• Power frequency: 50 / 60Hz
FIXTURE GROUND
• Rotary angle: 360°
WIRE
• Water-proof level: IPX5
OR
• Working humidity: < 93% RH
GREEN GROUND
SCREW
• Working temperature: -20° to +65°C (-4° to 149°F)
PAGE 1 of 6
COMMON
(WHT)
GROUND
LINE (BLK)
(GRN)
120V ONLY
GRN
BLK
WHT
BLK
WHT
RED
WHT
BLK
GRN
COMMON
(WHT)
LINE (BLK)
GROUND
120V ONLY
(GRN)
BLK
WHT
RED
GRN
BLK
WHT
"on" (approx 2 seconds to 80 minutes).
detection angle 180°; range 0m to 20m).
sensitivity 10Lux when set to min).
SPEC.NO. 93073512
09-01-2016
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Progress Lighting P6341
- Page 1 CAUTION: Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation. P6341 *************************************************************************************************************************************************************** WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full compliance with N.E.C. requirements. If there are any questions, contact a Qualified Electrical Contractor.
- Page 2 Choice of Location: The unit is designed to be mounted on a vertical surface 6 to 8 feet above the ground for optimum performance. Whenever possible, locate the unit so that its coverage area is away from heat sources or reflective surfaces, such as heating vents, air conditioners, large moving trees or pools of water.
- Page 3 Lire attentivement les consignes et couper le courant à partir du GARDE : disjoncteur principal avant de commencer l'installation. P6341 *************************************************************************************************************************************************************** AVERTISSEMENT : Si des dispositifs de commande spéciaux sont utilisés avec cet appareil d'éclairage, suivez attentivement les consignes afin d'assurer la conformité aux normes du Code national de l'électricité. Si vous avez des questions, contactez un entrepreneur-électricien qualifié.
- Page 4 Choix de l'emplacement : L'unité a été conçue pour être installée sur une surface verticale située entre 1,82 m et 2,43 m (entre 6 et 8 pieds) au-dessus du sol pour une performance optimale. Dans la mesure du possible, placez l'unité de sorte que sa zone de couverture soit loin de toute source de chauffe ou de toute surface réfléchissante, telle qu'un chauffage, un appareil de climatisation, un grand arbre en mouvement ou une piscine.
- Page 5 P6341 *************************************************************************************************************************************************************** ADVERTENCIA : si se usa algún dispositivo de control especial con este accesorio, siga con cuidado las instrucciones para garantizar el cumplimiento total con los requisitos de N.E.C.
- Page 6 Elección de la ubicación: La unidad se ha diseñado para montarse en una superficie vertical de 1,8 a 2,4 metros (de 6 a 8 pies) por encima del suelo para obtener un desempeño óptimo. Siempre que sea posible, coloque la unidad de modo que su zona de cobertura esté alejada de fuentes de calor o superficies reflectantes, como por ejemplo rejillas de calefacción, aparatos de aire acondicionado, árboles de gran tamaño o piscinas de agua.
Need help?
Do you have a question about the P6341 and is the answer not in the manual?
Questions and answers