Advertisement
Advertisement
Table of Contents
Summary of Contents for BlueCard BS-3000
- Page 1 BS-3000 Remote Communication Station (SMS Version) User’s Manual...
- Page 2 Two mobile phone SIM cards capable of sending SMS messages over the GSM network will be needed. One to install in the BS-3000 for it to upload guard tour data, the other to install in the mobile phone network modem connected to the computer so it can receive the guard tour data.
- Page 3 Data transfer from the reader to the BS-3000 has been completed. Short Beep (twice) + Long Beep (once) Data transfer from the BS-3000 to the remote location via the mobile phone network has been completed. Long Beep (once) + Short Beep (three times) The BS-3000 not operable and needs to be initialized by the manufacturer.
- Page 4 The number carried by the SIM card installed inside the mobile phone network modem that is connected to the computer must be stored into the BS-3000, so that it will know where to send the guard tour data it has collected.
- Page 5 Remote Setup (this can be done after MessageCenter has received at least one SMS message from the BS-3000. When this is done, the number carried by the SIM card inside the BS-3000 will be stored by MessageCenter and becomes selectable) Make sure the BS-3000 is turned on.
- Page 6 2002S, please place its reading head between the status lights, and set its top flush against the inside edge of the BS-3000. If there is data that needs to be transferred from the reader to the BS-3000, the blue LED light on the BS-3000 will start flashing rapidly, indicating that data is being transferred.
-
Page 7: Troubleshooting
Troubleshooting During Local Setup, the MessageCenter indicates that the number has not been stored properly. Shut down and restart MessageCenter and try again. The BS-3000 may have been going through the initialization process while MessageCenter tried to store the number.
Need help?
Do you have a question about the BS-3000 and is the answer not in the manual?
Questions and answers