Wlan Setup - Philips CMPD12CV-I User Manual

6.2.4

WLAN SETUP

The WLAN setup is strictly dependent on the existing wireless network infrastructure.
A example of WLAN setup is depicted:
● From the Ralink Wireless Utility icon on the Windows Taskbar select: "Start Windows Zero Configuration"
● Navigate through : "START -> Settings -> Control Panel -> Network Connections -> Wireless Network
Connection" and select one of the available networks.
● If required, insert a network key or password.
● To further configure the WLAN parameters on the "Wireless Network Connection" "Related Tasks" panel, select
"Change advanced settings".
● The "Wireless Network Connection Properties" dialog pops up, select "Wireless Networks" tab
● Select the preferred network and press "Properties" to adjust the authentication / encryption parameters.
6.2.5 ETHERNET LAN SETUP
Setting up an Ethernet connection is just a matter of plugging the Ethernet cable in the D-SUB 9 pins connector. It is
advised to switch off the WLAN connection in order to save battery power.
6.2.6 SCREEN BRIGHTNESS
The brightness level can be adjusted by going to:
"Control Panel > Tablet and Pen Settings > Display > Screen Brightness > Powered by Batteries" and by moving the slide
bar to "Bright".
14
Xper module