Summary of Contents for Orion fight-tech
- Page 1 Orion INTERACTIVE TRAINING SYSTEM NOTE: This instruction booklet contains safety information. PLEASE READ AND KEEP FOR FUTURE REFERENCE. ASSEMBLY MANUAL www.orionfighttech.com...
- Page 2 ASSEMBLE IN SEQUENTIAL ORDER • READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING UNIT. • CALL OR EMAIL WITH QUESTIONS: techsupport@ or call 1-800-xxx-xxxx • PUMP NEEDLE TO FILL AIR BAG MUST BE MOISTENED BEFORE INSERTING IN SPEED BAG. FIGHT TECH BY ORION...
-
Page 3: Maintenance
SCREWS BEFORE USING. • BASES CAN BE CLEANED WITH SOAP AND WATER. • SPEED BAG AIR SHOULD MAINTAIN AIR PRESSURE AT APPROXIMATELY 90 PERCENT OF THE BAGS CAPACITY (ONCE FILLED, BAG SHOULD BE SOFT ENOUGH TO S INTO). FIGHT TECH BY ORION... -
Page 4: Parts
15 LBS. STAND-ON BASE 54” X 24” X 3-7/8” 41.5 LBS. HEAD TARGET 15” X 12” X 5” 26 OZ. BEARINGS BEARING WASHER COLLAR BUSHING SPACER ROTATING ARM 26-1/4”X3-1/2”X3-1/2” 15.5 OZ. UPPER CUT TARGET 12-1/2”X3-1/2”X3-1/2” 14.5 OZ. FIGHT TECH BY ORION... -
Page 5: Hardware Identification
Hardware Identification ITEM QTY/SET DESCRIPTION NOTES 1/8” ALLEN WRENCH 3/16” ALLEN WRENCH ¼-20 SET SCREW ¼-28 SET SCREW 7 TOPS FLOOR FASTENERS SMALL BASE ONLY 7 BOTTOMS AIR PUMP AIR NEEDLE FIGHT TECH BY ORION... -
Page 6: Assembly
(2) set screws using the Place the foam spacer over the the 1/8 allen wrench provided. Do provided 1/8” allen wrench. shaft as shown. NOT over tighten. FIGHT TECH BY ORION... - Page 7 Secure in place pressure to the collar and tighten head target as shown above. Be using (2) set screws with the top collar. sure not to overfill-only fill to 90% 3/16” allen wrench. full. FIGHT TECH BY ORION...
-
Page 8: Instructions For Use
Instructions for Use Attaching The Base To A Mount Fight Tech comes with two optional mounts for the base of the machine. The first mount allows the user to attach the base to the floor and a second mount that doesn't require any floor attachments. For the floor mounting base, find a hard surfaced location that is best suited for the movement and activity required to use Fight Tech efficiently and make sure the surface area is clean of dirt and dry for proper adhesion. - Page 9 Instructions for Use Adding The Targets 1) The shaft is mounted onto the pre-drilled hole found in the base. When inserting the shaft twist the shaft into place. Do not force shaft down into base. Once the shaft makes contact with the stopper, tighten the three screws found on the side of pre-drilled hole to lock in place the shaft.
-
Page 10: Warranty
FightTech is designed to take punches of high magnitude, it does not have the durability of a punching bag under full strength strikes. We reserve the right to change or modify Fight Tech training units without notice. FIGHT TECH BY ORION...
Need help?
Do you have a question about the fight-tech and is the answer not in the manual?
Questions and answers