CABASSE stream BAR Owner's Manual page 25

4
POWERING ON THE REMOTE CONTROL
Before first use, loosen the screw (PH00 screwdriver), remove the back cover, remove the
battery protection tab, replace the cover, retighten the screw.
Replacement of the CR-2025 type battery in the Stream remote control: loosen the screw,
remove the rear lid, remove the old battery and load the new battery properly with the "+" side
on the clasp side, put the rear cover back on, retighten the screw.
CHECKING FOR TV SOUND
5
Plug one end of the power cord in the POWER connector at the back of the Stream BAR and the
other end into a live AC outlet. Stream BAR is ready to use as soon as the LED of the front display
turns red. Press the ECO on/off key of the remote to power the Stream BAR on. The LED turns
green, the screen displays "ON" followed by the name of the selected input.
INITIALIZATION OF THE WIRELESS CONNECTION BETWEEN BAR AND SUBWOOFER
a) Press the "PAIRING" switch at the back of the Subwoofer
b) Press and release after 5 secondes the "DIM" key of the remote control, the remote aiming
at the sound bar. A wheel on the screen shows that the set up is running.
c) The screen on the bar displays OK, the connection is effective.
Note: the DLNA fonction for Wi-Fi / Ethernet (WLAN/LAN) network use of Stream BAR is activated
when the PWR power LED at the back of Stream BAR has turned from red to green, around 40
seconds after having powered the Stream BAR on.
TV being on, select the Stream BAR input connected to the TV by pressing the key 3 of the remote
or the input selector of the bar until the screen displays the name of the right input:
- "HDMI TV" for the HDMI ARC input
- "OPT" for the optical input
StreamBAR_manual_A4 V5.indd 25
- "HDMI IN" for the HDMI input
- "AUX" for the analog input
25
6/10/2016 9:16:30 AM