Table of Contents
Advertisement
Quick Links
Bluetooth stereo headset user guide
Bluetooth Introduction
The Bluetooth headset is a portable headset solution based on Bluetooth wireless technology.
Bluetooth wireless technology is a short-range radio communication technology intended to
replace the cables connecting electronic devices. The technology uses a globally available
frequency range intended to ensure communication compatibility worldwide.
You can connect your headset to your mobile phone or any device with Bluetooth wireless
technology that supports the Headset profile or the Handsfree profile. When the headset is
connected to your mobile phone, you can handle incoming and outgoing calls, listen to music,and
adjust the volume, using the buttons on the headset.
The inbuilt BlueTooth Headset in motorcycle helmet contain BlueTooth Cell Discreteness、 Control
Buttons and Earphone.The BlueTooth Cell Discreteness contain Inserted BlueTooth、Battery and
Shell.
Bluetooth Cell Discreteness
Earphone
Control Buttons
Figure 1
Caution
Do not let your battery, charger, and headset get wet.
Listening at full volume to music or voice through a headset may damage your hearing.
BlueToothHeadSet Control Buttons
BUTTON_MFB
Call handling Button
BUTTON_VOL+ Volume Increase
BUTTON_VOL- Volume Decrease
BUTTON_PAIR
enter pairing mode
Advertisement
Table of Contents
Summary of Contents for Hehui Y6400
- Page 1 Bluetooth stereo headset user guide Bluetooth Introduction The Bluetooth headset is a portable headset solution based on Bluetooth wireless technology. Bluetooth wireless technology is a short-range radio communication technology intended to replace the cables connecting electronic devices. The technology uses a globally available frequency range intended to ensure communication compatibility worldwide.
-
Page 2: Getting Started
To use your headset, your phone or music device should support the following Bluetooth profiles: Profile Description Providing a wireless means for both remote control of the Mobile Phone by Hands-Free device voice HFP (HandsfreeProfile) connections between the Mobile Phone and the Hands-Free device. -
Page 3: Using The Headset
Charging Port Charging Port Rubber Cover Charging Plug Figure 2 Figure3 To turn the headset on Press and hold the Call Handling Button(MFB) for approximately 2 seconds until you hear a short low tone followed by a short high tone. The headset indicator light flashes yellow. When turned on, the headset automatically establishes handsfree phone and streaming music connections with the last connected Bluetooth devices (phone and/or music devices). -
Page 4: Adjusting The Volume
To Call Not every phone can support voice dial function,if your phone support voice dial then you can use headset to call someone. Otherwise,you using the keys on the phone, as usual. To make a call using voice dialing Make sure the phone and the headset are on and within range of each other. Press the Call Handling Button(MFB). - Page 5 Volume Increase Volume Decrease Button pair Control Buttons Callhandling Button Figure 4 To transfer the sound to the phone During a call using your headset, press the Call Handling Button(MFB) 2 times quickly for approximately 0.5 Seconds every times . If your headset work with HeadSetProfile, you just need turn down your headset.
- Page 6 Control lines plug Audio plug Inserted BlueTooth Speaker plug Figure 5 Open Direction Guideway of Inserted BlueTooth Figure 6 Note : no special need should not take out the Inserted BlueTooth.
- Page 7 FCC ID: VWU-Y6400 IMPORTANT REGULATORY INFORMATION This device complies with Part 15 of the FCC Rules: Operation is subject to the following two conditions: 1. This device may not cause harmful interference and 2. This device must accept any interference that is received, including any interference that may cause undesired operation.
Need help?
Do you have a question about the Y6400 and is the answer not in the manual?
Questions and answers