Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for RE-SOLUTION BGUIDE
- Page 1 BGUIDE ® MANUAL...
- Page 2 ® powered ON for a period of app. 40 minutes before operation. (Used before 40 minutes could add +/- 0,2 mm to the accuracy) Please note that for recharging of batteries the BGUIDE ® should be turned ON.
- Page 3 OBS 2 Just behind the “l” a flashing dot appears indicating that the measuring circuit is operational. If the dot disappears reset the BGUIDE (see below) Minimum : This figure shows the minimum measured distance between the surface and the steel belt since last resetting.
- Page 4 OPERATION: BUFFING CONTROL (Only start measuring after any pattern has been buffed off) Step 1. Take the BGUIDE out of the charge holder / Turn the ® BGUIDE ®...
- Page 5 CUSHION GUM CONTROL: 1)Mount the casing on the Extruder (extruder/builder combination) 2) Hold the BGUIDE® on to the casing and let it rotate full 360º in minimum 3 positions: Left Middle Right 3) Make a note of the “Min value” for each of the 3 positions.
-
Page 6: General Information
For any resetting use a small pick (tooth) or similar. Resetting should only be necessary in very special cases – such as a freezing display or similar. DIN socket: The DIN socket is fitted for internal calibration of the BGUIDE only ®... - Page 7 1. For a 100 % ( full ) recharge, the batteries should be recharged for a period of minimum 24 hours. 2. When not using it for measuring purposes place the BGUIDE in the charge holder and it will automatically ®...
-
Page 8: Technical Specification
Height: 150 mm Weight: 1,8 kg Power: 100 - 230Volt / 24 Volt – 50 HZ Battery: 10 pc – 1.5 Volt rechargeable type AA Contact: Vellingvej 9 DK- 8654 Bryrup Denmark Phone: +45 35 10 66 24 Mail: contact@re-solution.info...
Need help?
Do you have a question about the BGUIDE and is the answer not in the manual?
Questions and answers