Subscribe to Our Youtube Channel
Summary of Contents for JAC wiJAC-P Series
- Page 1 -Pxx (JA64/JA65) Wireless Stand Alone Intercom System Operating Manual Rev. A Page 1...
- Page 2 Copyright 2014 Jupiter Avionics Corp. All rights reserved Jupiter Avionics Corporation (JAC) permits a single copy of this manual to be printed or downloaded for personal use. Any such electronic or printed copy of this manual must contain the complete text of this copyright notice. Any unauthorized commercial distribution of this manual is strictly prohibited.
- Page 3 wiJAC-Pxx Wireless Stand Alone Intercom System Operating Manual Table of Contents Introduction ....................1 1.1 Unpacking ....................1 1.2 Verify Operating Region ................1 Headset Adapter Master/Slave (JA65/JA64) ..........2 Controls, Annunciators and Connectors ............2 (ON/OFF) Button.................. 2 3.2 VOX (Voice Operated Switch) ..............3 3.3 VOL (Phones Volume Control) ..............
- Page 4 wiJAC-Pxx Wireless Stand Alone Intercom System Operating Manual Table of Contents (Cont.) 6.3 Charging Operation – via Battery Charger ..........11 6.4 Battery Cautions and Warnings .............. 11 Accessories ....................12 7.1 JA72-005 Glove Box with USB connector ..........12 7.2 ProCS™...
-
Page 5: Introduction
• one to four Wireless Headset Adapter Slaves, JAC P/N JA64-00x • one set of AAA rechargeable batteries for each unit • one USB to Micro USB cable, JAC P/N CAB-USB-0003 for each unit. • one wiJAC™ Quick Start User Guide, JAC P/N DOC-GUID-WIPXXU •... -
Page 6: Headset Adapter Master/Slave (Ja65/Ja64)
wiJAC-Pxx Wireless Stand Alone Intercom System Operating Manual Headset Adapter Master/Slave (JA65/JA64) Note: The JA65 Headset Adapter Master and JA64 Headset Adapter Slave are superficially identical except for the colour of the ON/OFF button and MSTR (master) or SLAV (slave) on the blanking plate. Each system MUST utilize one JA65 (green button). -
Page 7: Vox (Voice Operated Switch)
wiJAC-Pxx Wireless Stand Alone Intercom System Operating Manual VOX (Voice Operated Switch) The Voice Operated Switch control is a rotary knob marked VOX located on the top of the Headset Adapter. To reduce the level of the sound needed to route the microphone audio to the other headset adapter(s), turn the VOX knob counterclockwise (ccw). -
Page 8: Annunciators
wiJAC-Pxx Wireless Stand Alone Intercom System Operating Manual Annunciators 3.7.1 PWR ON (Power On) The power on (PWR ON) annunciator is a green LED located on the right side of the unit. In addition to indicating that the unit is turned on, this annunciator indicates the connection status of paired units (see section 4.1) -
Page 9: Pairing And Purging Process
wiJAC-Pxx Wireless Stand Alone Intercom System Operating Manual Pairing and Purging Process The wiJAC-Pxx Wireless Intercom Systems consist of one JA65 Headset Adapter Master (green ON/OFF button), and up to four factory-paired JA64 Headset Adapter Slaves. Any additional Headset Adapter Slaves must be paired with the Headset Adapter Master before the expanded system can function correctly. -
Page 10: Purging
wiJAC-Pxx Wireless Stand Alone Intercom System Operating Manual Purging A JA65 that has already been paired with four JA64 headset adapters must be purged to clear any existing pairings if it is necessary to replace one or more of the headset adapters. Note: This process clears ALL previously paired units from the JA65. -
Page 11: Connecting The Wijac™ System
wiJAC-Pxx Wireless Stand Alone Intercom System Operating Manual Connecting the wiJAC™ System Note: The wiJAC-Pxx Wireless Intercom System Person to Person consists of one JA65 Headset Adapter Master and up to four JA64 Headset Adapter Slaves. Only paired units will operate together (see section A headset is inserted into the jack on the JA64/JA65 Headset Adapter, which is clipped to the user's belt or clothing. -
Page 12: Wijac™ System Operation
1.5 seconds. When the JA64 Headset Adapter battery charge is low, a triple-beep will be heard in the headset once every minute. Note: JAC recommends that the batteries should be charged or replaced immediately when the LOW BATT warning illuminates during use. -
Page 13: Loss Of Audio
wiJAC-Pxx Wireless Stand Alone Intercom System Operating Manual 5.2.7 Loss of Audio If there is no audio heard in the headset, check the PWR ON annunciator on the JA64 and the JA65 Headset Adapters. If a unit is off, turn it on and verify connection and operation. -
Page 14: Batteries
It should be possible to charge the unit via most USB power sources but this cannot be guaranteed for any products not made by or purchased from JAC. Where space allows, JAC recommends the JAC JA72-006 6 Dzus Glove Box... -
Page 15: Charging Operation – Via Battery Charger
wiJAC-Pxx Wireless Stand Alone Intercom System Operating Manual Charging Operation – via Battery Charger The batteries may be removed from the unit for charging in a separate battery charger. Removal of the batteries WILL NOT change any internal configuration of the unit. -
Page 16: Accessories
Battery Charger Recommendations To charge AAA NiMH batteries, JAC recommends the charger should have individual cell charging (so that three batteries may be charged at once), an automatic shut-off feature and a charge time of two to six hours. -
Page 17: Warranty
Contact JAC for any questions regarding this warranty and how it applies to your unit(s). JAC is the final arbiter concerning warranty issues. - Page 18 Jupiter Avionics Corporation 1959 Kirschner Road Kelowna BC Canada V1Y 4N7 Tel: +1 778 478 2232 Toll-Free: 1 855 478 2232 www.jupiteravionics.com...
- Page 19 - Pxx Stand-Alone (non-aircraft) Wireless Intercom System Data Sheet Description The wiJAC-Pxx system is a Stand-Alone Wireless Intercom System for up to five users, and provides a wireless full-duplex, hands-free audio network. The components connect to standard aircraft headsets and attach to the users’ belts, allowing operators free movement.
-
Page 20: Specifications
The wiJAC™ system is factory programmed with default settings that are suitable for most general (aviation-type) high impedance headsets. If it is necessary to modify the balanced phones/microphone input/output levels, this can be carried out by a JAC Dealer using JAC’s proprietary ProCS™ software. A configuration port is provided to support this function.
Need help?
Do you have a question about the wiJAC-P Series and is the answer not in the manual?
Questions and answers