Advertisement
Quick Links
SenseLife Cam
Indoor Air quality Monitor
User manual
SECTIONS:
Part 1. USB driver installation
Part 2. Program installation
Part 3. Set time and date
DO NOT PLUG THE CAM INTO YOUR PC BEFORE INSTALLING THE USB DRIVERS OR
IT WILL NOT WORK PROPERLY. IF YOU HAVE ALREADY PLUGGED THE CAM IN,
YOU MUST UNPLUG IT, REMOVE ANY "UNKNOWN DEVICE" DRIVERS, REBOOT, AND
FOLLOW THESE INSTRUCTIONS.
[This manual is subject to change without prior notice to increase user's convenience or to add
advanced functions]
Advertisement
Summary of Contents for cam SenseLife
- Page 1 Part 2. Program installation Part 3. Set time and date DO NOT PLUG THE CAM INTO YOUR PC BEFORE INSTALLING THE USB DRIVERS OR IT WILL NOT WORK PROPERLY. IF YOU HAVE ALREADY PLUGGED THE CAM IN, YOU MUST UNPLUG IT, REMOVE ANY ”UNKNOWN DEVICE” DRIVERS, REBOOT, AND FOLLOW THESE INSTRUCTIONS.
- Page 2 Part 1.USB driver installation 1. Go to www.co2meter.com/products/cam-co2-meter-powered-by-auto-home-or-usb 2. Save the file “USB Drivers (ZIP)” to your desktop. 3. Unzip the file and run the program CP210_Win2K_XP_S2K3.exe. Follow the on-screen instructions: Click “Next” 1. Click 2. Click “Next”...
- Page 3 Click “Next” Click “Install”...
- Page 4 Click “Launch” Click “Finish” 4. Connect the CAM to your computer by USB cable. You will see a pop-up Window similar to the one below (window can be different depending on your operating system). 1. Click 2. Click ”Next” BE PATIENT! It may take a few minutes until the wizard finishes searching. If the Wizard is unable to find the driver, hit the “<-back”...
- Page 5 Click “Finish” 5. To test for proper installation, Click “Start” “Control panel” “System” on your computer...
- Page 6 6. Click “Hardware” “Device Manager” 7. Click port (COM & LPT) 8. If you can see USB to UART COMXX the driver is successfully installed. If you cannot see it, go to the “Control panel” again and execute “Add new hardware” function. 9.
- Page 7 Part 2. Program installation 1. Save the “Program file (zip)” named CP210_run.zip to your desktop. Create a new folder, and unzip all the files into the new folder. 2. Double-click “CO2_Monitor.exe” in the folder to run the program. [1]Click SETTING 3.
- Page 8 [1]Click ”CONNECT” 6. CO2 concentration being displayed on CAM can be monitored. If the CO2 level in ppm does not respond, it is either because the wrong COM port number was selected in “Settings” or the USB driver was not properly installed. Try selecting each of the different COM ports under settings.
- Page 9 Part 3. Settings 1. Set the Time [1]Pressing “Mode” at least 2 [2]Set “Year” by “Up/Down” seconds, “Year” section flickers [3]Pressing “Mode” once, [5] Pressing “Mode” once, “Month” section flickers. Set “Day” section flickers. Set “Month” by “UP/Down” “Day” by “UP/Down” [4] Pressing “Mode”...
- Page 10 While time setting mode, you can finish setting by pressing “Mode” more than 2 seconds [1]Pressing “Down” more than 2 seconds, backlight will be 2. Backlight On/Off Off. In the light if Off, by pressing “Down” more than 2 seconds, backlight will be on...
Need help?
Do you have a question about the SenseLife and is the answer not in the manual?
Questions and answers