Advertisement
* NWI
When the device is activated, the device will check is it already adding
to the network? If doesn't, it will auto start the NWI mode. The LED
will flash in every second and continue 30 seconds. Until timeout or the
device successful to add by controller. Users can hold down the central
key, then press the top-right key three times within 1.5 seconds to
abort the NWI mode.
Over The Air (OTA) Firmware Update
The device support the Z-Wave firmware update via OTA.
Let the controller into the firmware update mode, and then hold down
the central key and press the top-right key to start the update.
After finish the firmware download, the LED will start flash in every 0.5
second. Wait the LED stop flash, the firmware update is succeeded.
Caution: Do not running the OTA when the battery is running low.
Security Network
The device support the security function. When the device included
with a security controller, the device will auto switch to the security
mode. In the security mode, the follow commands need using Security
CC wrapped to communicate, otherwise it will not response.
COMMAND_CLASS_BATTERY
COMMAND_CLASS_SIMPLE_AV_CONTROL_V1
COMMAND_CLASS_NOTIFICATION_V4
COMMAND_CLASS_ASSOCIATION_V2
COMMAND_CLASS_CONFIGURATION
COMMAND_CLASS_WAKE_UP_V2
Z-Wave Configuration Settings
Notice:
* All of the configuration, the data size is 1.
* The configuration mark with star(*), means after the remove the setting
still keep, don't reset to factory default. Unless the user execute the
"RESET" procedure.
Advertisement
