Download Print this page

Important Note - Intel RCM24G Manual

Radio control module 2.4 ghz

Advertisement

MHz and 5650-5850 MHz and that these radars
could cause interference and/or damage to LE-
LAN devices.
iii. for devices with detachable antenna(s), the
maximum antenna gain permitted for devices in
the bands 5250-5350 MHz and 5470-5725 MHz
shall be such that the equipment still complies
with the e.i.r.p. limit;
iv. for devices with detachable antenna(s), the
maximum antenna gain permitted for devices in
the band 5725- 5850 MHz shall be such that the
equipment still complies with the e.i.r.p. limits
specified for point- to-point and non-point-to-
point operation as appropriate

Important Note

Changes or modifications made to this equipment not expressly approved by Intel Corporation may
void the FCC authorization to operate this equipment.
The product is provided with an approved antenna. Use only supplied or approved antenna by Intel
Corporation. Any changes or modifications to the Antenna may void the FCC regulatory approvals
obtained for the product.
End-users and installers must be provided with antenna installation instructions and transmitter
operating conditions for satisfying RF exposure compliance.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least
20 cm from all persons. RF exposure compliance must be ensured by integrator.
Contact
Intel Corporation
2200 Mission College Boulevard
Santa Clara, CA 95054
(c.-à-d., qu'ils ont la priorité) pour les bandes
5250-5350 MHz et 5650-5850 MHz et que ces
radars pourraient causer des interférenceset/ou
des dommages aux dispositifs LAN-EL.
iii. Pour les dispositifs dotés d'antenne (s)
amovible (s), le gain d'antenne maximal autorisé
pour les dispositifs dans les bandes 5250-5350
MHz et 5470-5725 MHz doit être tel que
l'équipement soit toujours conforme aux normes
e.i.r.p. limite;
iv. Pour les dispositifs dotés d'antenne (s)
amovible (s), le gain d'antenne maximal autorisé
pour les dispositifs de la bande 5725- 5850 MHz
doit être tel que l'équipement soit toujours
conforme aux normes e.i.r.p. Limites spécifiées
pour les opérations point à point et non point-à-
point selon le cas
Page 5 of 5

Advertisement

loading