Download Print this page

FEA Labs PHOTON FUZZ MK2 Manual

Advertisement

Quick Links

Battery replacement:

FEA
Remove the four screws on the bottom cover to access the battery
compartment. If storing the unit for long periods of time the battery
PHOTON FUZZ MK2
should be removed to prevent corrosion of the battery snap. Be sure
to place the battery wires along the side of the battery in the battery
pocket and use care while replacing the bottom cover.
Warranty:
The FEA PHOTON FUZZ is fully covered for a period of 5 (five) years
and the foot switches are covered for 1 (one) year against defects in
material and workmanship. Abuse and neglect are not covered under
the warranty. Any modifications or repairs not authorized by FEA
voids all warranties. The customer will be responsible for shipping
cost to and from FEA Labs for repairs. Contact me before attempting
to ship a unit for repair at: info@fealabs.com.
All repairs made outside of the warranty period will be very
reasonable (usually only the cost of the parts)... your satisfaction is
priority one.
Contact FEA Labs at:
www.fealabs.com
info@fealabs.com
REV 2.1
www.fealabs.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the PHOTON FUZZ MK2 and is the answer not in the manual?

Questions and answers

Summary of Contents for FEA Labs PHOTON FUZZ MK2

  • Page 1: Battery Replacement

    Any modifications or repairs not authorized by FEA voids all warranties. The customer will be responsible for shipping cost to and from FEA Labs for repairs. Contact me before attempting to ship a unit for repair at: info@fealabs.com.
  • Page 2: Technical Specifications

    About the design: Technical Specifications: The Photon Fuzz MK2 gets its name from an active component in the  DRIVE gain (max): +54dB circuit that utilizes infrared light to control the fuzz distortion element. Light is made up of photon particles, so the name represents the ...
  • Page 3 DIP Switch Settings: The 2-band EQ is an active Baxandall boost/cut design. The EQ is only applied to the fuzz signal, so that your dry signal remains natural. The octave distortion is selected by a footswitch. The octave is a full-wave rectifier distortion circuit located after the fuzz and its 2- band EQ circuit.
  • Page 4  The “switch on” power supply current is less than 1µA Features: (micro amp) on the signal ground at the INPUT jack. This is approximately 45,000 times (-93dB) less than the commonly used method of connecting the battery’s negative terminal ...