Page 1
Follow Spotlight 575, 700, 1200 Watt Metal Halide 1000, 2000 Watt Tungsten-Halogen Rev. Feb 20 12 CantoUSA 1092 West Atlanta Street Marietta , Georgia 30060 USA Tel 888/252-5912 • Fax 866 /260 -3549 www.cantousa.com...
Page 2
Carefully read user’s instructions before using this lighting unit. The instructions given here insure safe and correct usage of this product. User’s failure to comply with the installation, operating, maintenance and safety procedures outlined in this manual, as well as those generally applicable to this lighting equipment, may cause the spotlight to perform in an unsatisfactory manner.
United States by Strong Entertainment Lighting. The metal halide Canto models are available in 575, 700, and 1200 watt models, and require use of a separate power supply unit of the correct wattage. Each power supply operates from a 120 volt, 15 ampere AC line. Tungsten-halogen models, using either a 1000 watt FEL or 2000 watt GAE bulb, operate from a 120 volt AC line (20 ampere service required for 2000 watt model).
Page 4
CANTO SPOTLIGHT Iris Control Lever Cooling Fan Optical System Lamphouse Fade-Out/Douser Control Lever Color Boomerang (optional) Lampholder Tilt Friction Brake Control Lever Yoke Tripod Floor Stand (optional) Power Supply Unit (Metal Halide models only)
Page 5
Iris (blackout iris diaphragm if specifically ordered; not available for Canto 2000) c. Truss pin/spigot (1.11" diameter) with 12mm self-locking nut and plain washer d. Instruction manual Power Supply (only for Canto 575, Canto 700 and Canto 1200 metal halide) a. 110/120 Volt, 50/60 Hz. ballast 2. MOUNTING THE SPIGOT/TRUSS PIN a.
Page 6
Important Notice: while the lamp is on. . . Do not leave the iris closed for longer than: • 10 minutes on Canto 575, Canto 700, Canto 1000 and Canto 1200 • 2 minutes on Canto 2000 Use the douser (front lever) to cut off the light should you require to have the lamp “on” with no beam projecting to the stage.
Page 8
HAS BEEN SWITCHED “OFF” FOR AT LEAST 30 MINUTES 13. SPOTLIGHT SETUP If you have purchased a metal halide unit (Canto 575, Canto 700, Canto 1200) we strongly recommend you check the lamp alignment of your followspot as follows: a. Switch on the unit and project the beam on a flat surface (a wall, for example) at a short distance (three to six feet/one to two meters).
14. FOCUSING This fixtures features a variable beam angle from 8° to 22°. The variable beam is altered by adjusting the front and rear zoom lenses in relation to each other. The front lens defines the beam spread (spot size), the rear lens the focus degree of “softness”...
Our warranty covers all structural and manufacturing defects for one (1) year from the date of purchase. If a unit proves defective, contact the Strong Entertainment Lighting dealer who supplied the product and report the serial number of the unit. 19. WIRING DIAGRAMS Canto 1000, 2000 (Tungsten-Halogen) Canto 575, 700, 1200 (Metal Halide)
20100807 Gobo Holder, A/B Size Canto Replacement Parts Part No. Description 20015781 Power Supply Unit, 575 Watt Metal Halide 20017081 Power Supply Unit, 700 Watt Metal Halide 20018581 Power Supply Unit, 1200 Watt Metal Halide 20100707 Iris 80FO5029 Fade-Out/Douser 80LE4127...