Sanyo CRD-BPDV3 Owner's Manual page 25

Page 24
Document No.
(1/1)
(1) How to use
Before using this product, make sure that the device driver for the Combo driver is installed in
the personal computer.
1) How to insert the disc.
i. Turn on the power of the main machine where the product is attached.
ii. Press the eject key to open the disc tray.
iii. Place the disc on the tray so that the printed side is upside.
iv. Press the eject key to close the disc tray.
v. Read the disc. The read indicator goes on-and-off during the TOC read operation. Then
the indicator goes on.
Write the data onto the disc. The write indicator goes on while the data is written.
2) How to take out the disc.
i. Make sure that each indicator is OFF.
ii. Press the eject key to open the disc tray.
iii. Take out the disc.
iv. Press the eject key to close the disc tray.
3) How to take out the disc in an emergency.
When the disc can't be ejected because of power failure or run-away of the software, take the
following measures to force the take out of the disc.
i. Prepare a steel paper clip. Extend the paper clip.
ii. Insert the end of the paper clip into the emergency eject hole and press it strongly to eject
the disc tray.
iii. Pull the disc tray toward you and take out the disc.
Push back the disc tray.
(2) Product ID, Vender ID
Product ID: CRD-BPDV3, Vender ID: GENERIC
Document Name
Handling Manual
SANYO Electric Co., Ltd.