For hand operated, heat transfer press with interchangeable plates and automatic opening (17 pages)
Summary of Contents for Lotus LTS 138 b
Page 1
Operating instructions for Hand operated Transfer Press LTS 138 b + 150 b with interchangeable plates ä LOTUS PRESS s.r.l. LOTUS TRANSFERS INTERNATIONAL e.K. Via Giambellino 14a Anklamer Str. 38 20146 Milan ITALY 10115 Berlin GERMANY Tel. +39. 02. 48 95 03 86 Fax +39.
Thank you very much for buying our Lotus heat transfer press. We are sure you will Operating Instructions LTS 138 b + LTS 150 b capitalise on this excellent unit for years if you take the time to read these instructions carefully.
Any claims of consequential costs of a loss or damage, e.g. loss of production, are explicitly excluded from this warranty. No distributor, representative or agent is author- ised to assume for Lotus Press any other obligation or liability or to submit a statement different from the one mentioned above.
3. Cap and Plate Set Operating Instructions LTS 138 b + LTS 150 b For this model you may purchase easily interchangeable sets for converting the press: a. Cap set with a bent heating plate and bent supporting plate (cf. fig. a) b.
Not more than one person may operate the press at a time. Avoid exceeding the spec- ified maximum temperature when operating the press. Lotus Press is not liable for faults, accidents, damages, losses etc. resulting from not following the instructions in this manual.
Lotus Press s.r.l. is not liable for damages, losses, injuries or consequential damag- Operating Instructions LTS 138 b + LTS 150 b es resulting from acts, changes or other use of the transfer press not authorised by a prior written consent from Lotus Press s.r.l.
The power socket must have an electric protective grounding and a residual-current- Operating Instructions LTS 138 b + LTS 150 b operated protective device (RCD) disconnecting the circuit if the residual current ex- ceeds 30 mA. Do not use cables with damaged insulation. It is inadvisable to use extension cords.
Page 8
7) Put the textile to be printed on the supporting plate and place the desired transfer Operating Instructions LTS 138 b + LTS 150 b onto it. 8) To start the transfer process, pull down the lever. This will cause the press to close and the heating plate will be pressed onto the supporting plate.
9. Maintenance Operating Instructions LTS 138 b + LTS 150 b Following the safety directions mentioned below is essential to avoid severe in- juries to the operator and/or damage to the transfer press. Before performing any maintenance work, the transfer press must have been switched off and the plug must have been removed from the power socket.