1. Manuals
  2. Brands
  3. OPENPEAK Manuals
  4. Control Panel
  5. OpenFrame 7E
  6. Quick start manual

OPENPEAK OpenFrame 7E Quick Start Manual

Multimedia home energy management device
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
OpenFrame
7E
®

Quick Start Guide

© 2010 OpenPeak. All Rights Reserved.
1

Advertisement

Table of Contents
loading

Summary of Contents for OPENPEAK OpenFrame 7E

  • Page 1: Quick Start Guide

    OpenFrame ® Quick Start Guide © 2010 OpenPeak. All Rights Reserved.

  • Page 2: What's Inside

    What’s Inside BOX CONTENTS OpenFrame 7E base OpenFrame 7E base power adapter Ethernet cable Cleaning cloth © 2010 OpenPeak. All Rights Reserved.
  • Page 4 The base router, or plug directly into router unit will automatically begin the using the supplied Ethernet cable. power-on sequence. Ethernet cable for wired connection only. © 2010 OpenPeak. All Rights Reserved.

  • Page 5: Service Set Up

    To enter information in a blank Using the On-screen field, touch the empty field with Set Up Wizard your finger to bring up the Now that your OpenFrame 7E is keyboard screen. powered-up, on-screen instructions will walk you through the simple set up.

  • Page 6: Troubleshooting

    Ethernet cable is securely your usual home page. connected at both ends. Contact your Internet provider if you believe you aren’t getting a signal. © 2010 OpenPeak. All Rights Reserved.
  • Page 7 4. Restart the Device Unplug the power cord from the outlet, wait 15 seconds, then plug the power cord back in. Your unit will restart.

  • Page 8: Important Customer Information

    Important Customer Information and/or copying OpenFrame 7E WARRANTY Base or the Open Source If your OpenFrame 7E Base Software, you (the licensee) malfunctions as a result of a agree that you have read, manufacturing defect within understand, and will comply...
  • Page 9 Customer Information (continued) interference will not occur in This device complies with a particular installation. If this Part 15 of the FCC Rules. equipment does cause Operation is subject to the harmful interference to radio following two conditions: (1) or television reception, which This device may not cause is found by turning the harmful interference, and (2)

  • Page 10: Important Note

    The installation of the base unit should allow at least 20 centimeters between the base and persons to be in compliance with FCC RF exposure guidelines. The FCC ID is located on your device. ©2010 OpenPeak. All Rights Reserved.

  • Page 11: Important Safety Information

    Important Safety Information Please read the following 5. This product should be important safety notices and operated using the type of instructions before installing or power indicated on the marking using the product. label. If you are not sure of the type of power available, consult •...
  • Page 12 15A U.S. is used on the phase electrical storms. conductors (all current-carrying To avoid electric shock, do not conductors). Unplug this use this product in or near product from the wall outlet water. ©2010 OpenPeak. All Rights Reserved.
  • Page 13 and refer servicing to qualified CAUTION—DISPOSAL service personnel under the This product contains harmful following conditions: substances. Ultimate disposal of a. When the power cord or plug this product should be handled is damaged or frayed. according to all applicable laws b.
  • Page 14 LCD breaks and internal fluid gets into your eyes or on your hands, immediately wash the affected areas with water for at least 15 minutes; if any symptoms are present after washing, seek medical care. ©2010 OpenPeak. All Rights Reserved.
  • Page 15 © 2010 OpenPeak. All Rights Reserved.

Table of Contents