Summary of Contents for JJPlus JWAP223
-
Page 1: Technical Support
Technical Support The support team can help you with setup, or questions about range and performance. Email: Repeater Manual service@jjplus.com Your repeater default settings: SSID and Password Sticker Location... - Page 2 FCC ID: W23-JWAP223 Step 1: Attach the antenna Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. Screw on the antenna before plugging 15.105(b) This equipment has been tested and found to comply with the limits for a...
- Page 3 Step 2: Find a suitable location Step 3: Connect to repeater From your computer, tablet or phone, scan for the Plug the repeater into an outlet near the computer network name shown on the cover of this booklet. that currently has a weak or low signal. ...
- Page 4 Step 4: Open a browser Step 5: Extend a network Open a web browser then go to: The repeater will scan for nearby networks. http://192.168.100.2 Select the network you are trying to extend. If you do not see your network, click the refresh button below the list of networks.
- Page 5 Step 6: Connect Step 7: Test your connection Enter the password of the network you are Try loading a new web page such as Yahoo.com trying to extend, if required, then click “Join”. If you can load your test web page, then you are finished.
-
Page 6: Troubleshooting
Wait 30 seconds, then scan for a network called You can disable the lights for use in a bedroom or other area. “jwap223”. After you connect, set a new password and network name on the settings page. Support information is on the back of this page.
Need help?
Do you have a question about the JWAP223 and is the answer not in the manual?
Questions and answers