Download Print this page

Redback A 5350 Operating Instructions page 4

2 way stereo / 3 way mono active crossover

Advertisement

A 5350 SPECIFICATIONS
INPUT:
Connectors:
Type:
Impedance:
Max Input Level:
CMRR:
OUTPUT:
Connectors:
Type:
Impedance:
Max Output Level:
>+21 dBu balanced/unbalanced into 2 kohm or greater
PERFORMANCE:
Bandwidth:
Frequency Response:
Signal-to-Noise:
Low Output:
Mid Output:
High Output:
Dynamic Range:
THD+Noise:
Interchannel Crosstalk:
CROSSOVER FREQUENCIES:
Stereo Mode:
Low/High:
Mono Mode:
Low/Mid:
Mid/High:
Filter Type:
WARNING
FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:
WATER AND MOISTURE: Appliance should not be used near water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet base-
ment, or near a swimming pool, etc). Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through
openings.
POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as
marked on the appliance.
GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated.
POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon
or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.
SERVICING: To reduce the risk of fire or electric shock, the user should not attempt to service the appliance beyond that described in the
operating instructions. All other servicing should be referred to qualified service personnel.
FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE: Replace fuse with same type and rating only.
ELECTROMAGNETIC COMPATIBILITY
This unit conforms to the Product Specifications noted on the Declaration of Conformity. Operation is subject to the following two conditions:
• this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired operation.
Operation of this unit within significant electromagnetic fields should be avoided.
Use only shielded interconnecting cables.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
RISK OF ELECTRIC SHOCK - DO NOT OPEN
There are no user serviceable parts inside the unit. Do not open the unit. Do not attempt to service the unit yourself. Refer all servicing to
qualified personnel. Opening the chassis for any reason will void the manufacturer's warranty. Do not get the unit wet. If liquid is spilled on
the unit, shut it off immediately and take it to a dealer for service. Disconnect the unit during storms to prevent damage.
Electronically balanced/unbalanced, RF filtered
Balanced > 50 kohm, unbalanced > 25 kohm
+22 dBu typical, balanced or unbalanced
>40 dB, typically > 55 dB at 1 kHz
Impedance-balanced/unbalanced, RF filtered
Balanced 200 ohm, unbalanced 100 ohm
20 Hz to 20 kHz, +0/-0.5 dB
< 3 Hz to > 90 kHz, +0/-3 dB
Ref: +4 dBu, 22 kHz measurement bandwidth
Stereo Mode:
Mono Mode:
> 94 dB
> 94 dB
> 93 dB
> 91 dB
> 91 dB
> 106 dB, unweighted, any output
< 0.004% at +4 dBu, 1 kHz
< 0.04% at +20 dBu, 1 kHz
< -80 dB, 20 Hz to 20 kHz
45 to 960 Hz or 450 Hz to 9.6 kHz (x10 setting)
45 to 960 Hz or 450 Hz to 9.6 kHz (x10 setting)
45 to 960 Hz or 450 Hz to 9.6 kHz (x10 setting)
Linkwitz-Riley, 24 dB/octave, state-variable
Distributed by Altronic Distributors Pty. Ltd. Perth. Western Australia.
Phone: 1300 780 999 Fax: 1300 790 999
FUNCTION SWITCHES:
XLR
Low Cut:
Phase Invert:
x10:
Mode:
LF Sum: Selects normal (stereo) or mono-summed low frequency operation.
XLR
INDICATORS:
Stereo Operation:
Mono Operation:
Low Cut:
x10:
Phase Invert:
POWER SUPPLY:
Operating Voltage:
Power Consumption:
PHYSICAL:
Dimensions:
Weight:
Internet: www.altronics.com.au
Activates 40 Hz Butterworth, 12 dB/octave high-pass
Inverts the phase at the output, one switch per output.
Multiplies crossover frequency range by 10, one switch per channel.
Selects stereo/mono and 2/3/4-way operation.
filter, one switch per channel.
Green LED
Yellow LED
Red LED per channel
Green LED per channel
Red LED per output (3 per channel)
240 VAC 50/60 Hz
15 Watts
44 x 483 x 175mm
2kg

Advertisement

loading