AEG FSE73300P User Manual page 10

10 www.aeg.com
Whether you use a standard detergent
or multi-tabs (with or without salt), set
the proper water hardness level to
keep the salt refill indicator active.
Multi-tabs containing salt
are not effective enough to
soften hard water.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
flash and the display is blank.
2. Press
• The indicators
are off.
• The indicator
• The display shows the current
setting: e.g.
3. Press
setting.
4. Press the on/off button to confirm
the setting.
6.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
It is possible to set the released quantity
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
and
, , ,
.
, ,
still flashes.
= level 5.
repeatedly to change the
and
, , ,
start flashing and the display is
blank.
2. Press
• The indicators
are off.
• The indicator
flash.
• The display shows the current
setting: e.g.
– The levels of rinse aid range
3. Press
setting.
until
4. Press on/off to confirm the setting.
and
6.4 The rinse aid empty
notification
and
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If the drying results are
satisfactory while using multi-tablets
only, it is possible to deactivate the
notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start flashing and the display is
blank.
2. Press
until
• The indicators
and
are off.
.
, ,
continues to
= level 4.
from 0A to 6A where level 0A
means rinse aid is not used.
repeatedly to change the
and
, , ,
.
, ,
and
until
and
and