Do you have a question about the HV-25 and is the answer not in the manual?
Questions and answers
Jess Pormiel
February 3, 2025
Hello. I have an Autoclave model HV-50L that beeps whenever a cycle is running or after it has completed. We have looked to the manual and tried to do suggested troubleshooting, but it continues to beep
1 comments:
Mr. Anderson
February 10, 2025
The beeping sound in the HIRAYAMA HV-50L autoclave could be caused by the following:
1. Error Detection Alarm – If a malfunction occurs, the error detection circuit is triggered, displaying an error number on the digital display and sounding an electronic alarm. Possible causes include: - Lack of water in the system. - Clogged piping due to a waste disposal bag or other obstruction.
2. Warming Cycle Notification – During the warming cycle (Modes 1 and 4), the electronic alarm beeps when the temperature in the working chamber falls to the set incubation temperature.
To stop the alarm: - For an error, check the error number, press the START/STOP switch, and resolve the issue. - For the warming cycle, wait for the cycle to complete or stop it manually by pressing the START/STOP switch.
Need help?
Do you have a question about the HV-25 and is the answer not in the manual?
Questions and answers
Hello. I have an Autoclave model HV-50L that beeps whenever a cycle is running or after it has completed. We have looked to the manual and tried to do suggested troubleshooting, but it continues to beep
The beeping sound in the HIRAYAMA HV-50L autoclave could be caused by the following:
1. Error Detection Alarm – If a malfunction occurs, the error detection circuit is triggered, displaying an error number on the digital display and sounding an electronic alarm. Possible causes include:
- Lack of water in the system.
- Clogged piping due to a waste disposal bag or other obstruction.
2. Warming Cycle Notification – During the warming cycle (Modes 1 and 4), the electronic alarm beeps when the temperature in the working chamber falls to the set incubation temperature.
To stop the alarm:
- For an error, check the error number, press the START/STOP switch, and resolve the issue.
- For the warming cycle, wait for the cycle to complete or stop it manually by pressing the START/STOP switch.
This answer is automatically generated