Advertisement
SYNC to Phone
1. Turn OFF bluetooth on all phones in the reception area
except the phone you will sync to. Turn it's bluetooth ON.
2. Connect phone to internet and open Bit AR App.
3. Squeeze AR BLASTER's Trigger for 30 seconds.
AR Blaster should now be synced with your phone. If sync
doesn't occur, close Bit AR App and repeat above steps.
Game Interface will appear on phone when synced.
NOTES:
1. AR BLASTER can only sync with one phone at a time.
2. When not using AR BLASTER for 10 minutes or more, it will
enter SLEEP mode. To re-start, make sure phone bluetooth
is ON - then hold trigger for 3 seconds. If AR Blaster does
not re-SYNC, fully exit the Bit AR Club app on your phone.
Re-open it and start the re-sync again. NOTE: If you are
unable to fully exit the app, an alternative method is to
remove the batteries for AR Blaster and re-insert, then re-
sync.
3. If using Android phone, make sure Security Settings are set
to allow for installation of apps from unknown sources.
4. To change phones, remove and re-insert batteries in AR
BLASTER, then follow sync procedure for new phone sync.
4
Advertisement
