Table of contents Table of contents About these instructions for use Target groups Labelling of notes About this translated version Product information Safety advice Intended use 2.2.1 Areas of use Product description 2.3.1 Overview Handling Assembly information 3.1.1 Required material and tools Assembly 3.2.1 Mounting the tablet holder...
This restriction does not extend to possible operating instructions. The installation of Viega products must take place in accordance with the general rules of engineering and the Viega instructions for use.
About these instructions for use About this translated version This instruction for use contains important information about the choice of product or system, assembly and commissioning as well as intended use and, if required, maintenance measures. The information about the products, their properties and application technology are based on the current standards in Europe (e.
2.2.1 Areas of use The tablet holder is used to feed freshener blocks into the Viega cis- terns. The tablet holder is suitable for the concealed cisterns 2H, 2C, 2S and 1F. Only suitable for the flush plate Visign for Style 10, model 8315.1.
Handling 3 Handling Assembly information 3.1.1 Required material and tools The following material and tools are required for mounting: Flush plate Visign for Style 10, model 8315.1 Phillips screwdriver Knife (cutter) Assembly 3.2.1 Mounting the tablet holder Requirements: For new installations: The cistern and flush actuation have been mounted.
Page 9
Handling Insert the threaded bolts so deep that the upper edge of the threaded bolt sticks out max. 20 mm behind the wall surface. Fasten the threaded bolts with a 90° turn. 90º Insert the base frame. INFO! Mind the mark "Top". Use the screwdriver to screw the base frame down hand-tight without distorting the base frame.
Page 10
Handling Adjust the actuating rods flush with the base frame. If necessary, use a cutting knife to cut the actuating rods to length at the thread. Insert the support in the base frame. Attach the sticker "No chlorine" to the support. Lightly press the bottom guide rails inwards.
Handling 3.3.1 Using the tablet holder The flush plate has been installed. Use both your hands to pull the flush plate forward to remove it. Remove the flush plate. Tablet holder 11 from 12...
Handling Feed the freshener block into the tablet holder. NOTICE! Do not use liquid cleaner. Use both your hands to raise the flush plate. Replace the flush plate. Disposal Separate the product and packaging materials (e. g. paper, metal, plastic or non-ferrous metals) and dispose of in accordance with valid national legal requirements.