Table of Contents
Advertisement
Continuity
AVOID ELECTRICAL SHOCK AND INJURY.
CIRCUIT
AND
DISCHARGE
MEASURING THE CONTINUITY.
1. Insert the black lead into "COM" input and the red lead into
"INPUT" input.
2. Turn the rotary switch to
3. Press "FUNC" button to switch to continuity ( ) mode.
4. Connect leads to the circuit terminals.
5. The Meter will beep if the reading is below 50.
6. Read the measurement from the display.
Attention:
The Meter displays "OL" if the circuit is open or resistance is larger
than 600.
Capacitance Measurement
AVOID ELECTRICAL SHOCK AND INJURY. DISCHARGE THE
CAPACITOR BEFORE PERFORMING THE MEASURING.
1. Insert the black lead into "COM" input and the red lead into
"INPUT" input.
2. Turn the rotary switch to
WARNING
POWER OFF THE
THE
CAPACITANCE
BEFORE
.
WARNING
.
3. Place leads at the terminals of the capacitor after it is
discharged.
4. Read off the measurement from the display.
Attention：
To improve the accuracy of measurements below 10nF, subtract
the distributed capacitance of the meter and cable.
Maintenance
General Maintenance
To avoid possible electric shock or personal injury, repairs or
servicing not covered in this manual should be performed only
by qualified personnel.
To avoid electrical shock, remove any input signals before
cleaning.
To avoid false readings that could lead to possible electric shock,
replace the batteries as soon as the low battery indicator "
appears.
Clean the instrument case with a damp cloth and mild detergent.
Do not use aromatic hydrocarbons or chlorinated solvents for
cleaning.
"
15
Advertisement
Table of Contents
