Advertisement
10.
Power save:
The Receiver Collar will go into deeply sleep if no operation for 5 minutes. The Indicator Light went out.But
•
now the Receiver Collar also can receive the Remote Transmitter single normally.
•
The Remote Transmitter will go into Standby mode if there is no operation after 8 seconds, press any
button can activate the Remote Transmitter from Standby mode. And press Mode button for more than 3 seconds
go into deeply sleep，press Mode button for more than 3 seconds to activate the Remote Transmitter from deep
sleep mode
11.
The system can be used for 1 or 2 or3 Receiver Collars.
Two pairs of metal prong (short/long) to suit dogs with varied fur thickness.
12.
Operating Guide
Prepare the Remote Transmitter and Prepare the Receiver
Collar
Charge the Remote Transmitter and Receiver Collar
1. Connect one of the USB connector to the Remote Transmitter Charging Jack.
2. Plug the charger into a standard wall outlet.
3. Charge the Remote Transmitter at least 5 hours for the first charge. Recharges take only 3-4 hours.
4.The Indicator Light on the Remote Transmitter will be fast flash every half second.
5.After fully charged ，the Indicator Light will be back to standby status automatically.
6. The Receiver Collar aren't waterproof without the rubber cover .So should be replace the cover tightly when charging
is complete.
Battery Indicator
Battery is at 2⁄3 to Full capacity. The Indicator Light's color is green
Battery is at 1⁄3 capacity. The Indicator Light's color is yellow
Battery is at 1⁄6 capacity. The Indicator Light's color is red
When the Battery Indicator shows the low battery symbol (
outline is displayed, the Remote Transmitter's battery is unable to power transmissions to the Receiver. Transmitter must be
recharged to regain operation
Power on or off the Remote Transmitter
To power on the Remote Transmitter rotate Intensity Dial so it's no longer selecting "off".If done correctly, the
Remote Transmitter Light will be flashing green.
To power off the Remote Transmitter rotate Intensity Dial select "off", the Remote Transmitter Light will be go out.
Power on or off the Receiver Collar
To power on the Receiver Collar,align the Remote Transmitter Pairing Receptacle with the corresponding
Receiver Collar Pairing Receptacle more than 1 second and put the Remote Transmitter away.Once the the
Indicator Light of flash very fast for about 2 seconds and then to standby status. The Receiver Collar is now on.
To power off the Receiver Collar, the Remote Transmitter Pairing Receptacle with the corresponding Receiver
Collar Pairing Receptacle more than 1 second and less than 3 seconds,then put the Remote Transmitter
⁄
capacity), recharge your Transmitter soon. When the battery
1
6
Advertisement
