Summary of Contents for ACL VC PANNING AMPLIFIER
- Page 1 VC PANNING AMPLIFIER LVL/PAN GAIN GAIN GAIN VC PANNING AMPLIFIER User’s Manual PAN CV PAN CV Eurorack Synthesizer Modules...
-
Page 2: Table Of Contents
TABLE OF CONTENTS 1.INTRODUCTION 2.WARRANTY 3.INSTALLATION 4.FUNCTION OF PANEL COMPONENTS 5.CHARACTERISTICS 6.SPECIFICATIONS... -
Page 3: Introduction
1. INTRODUCTION Audiophile Circuits League-VC PANNING AMPLIFIER is especially designed to process audio signals, dynamically positioning them in a stereo feld. If mono signals are processed, the unit can be also operated as two standalone VCAs. The Circuit is designed for low distortion, low CV feed-trough and low noise. -
Page 4: Warranty
2. WARRANTY Is it a malfunction? In the event of a fault in use, we will repair or replace it free of charge under the warranty terms stated below. The warranty period is valid for one year from the Please read the user's manual carefully and checking again. If you think that day of purchase. -
Page 5: Installation
3. INSTALLATION WARNING *Always turn the Eurorack unit off and unplug the power cord before pluging GATE the Eurorack power cable. *When attaching the Eurorack power cable, please be careful not to touch the Projection terminal part. +12V Connect to the Eurorack's system power supply (+ 12V) using the supplied Eurorack power cable. -
Page 6: Function Of Panel Components
4. FUNCTION OF PANEL COMPONENTS “GAIN” knob ① Gain Attenuverters for the output jacks ⑨"OUT 1" and "OUT 2". “IN” knob ② Attenuators for adjusting the input levels from jacks ⑥ "IN 1" and ⑦ "IN 2". “CV” knob ③ Attenuverters for adjusting the input CV signals from ④... - Page 7 "PAN CV" input jack ⑧ Input the CV signal for controlling PAN. "OUT 1 " "OUT 2 " output jacks ⑨ Outputs for each of channels 1 and 2. "PAN CV" knob ⑩ Attenuverter for adjusting the gain of channels 1 and 2. "PAN CV"...
-
Page 8: Characteristics
5. CHARACTERISTIC CV input 1 is normalized (internally connected) to CV 2. “Normalization” means Conversely, when inputs of CV 1and 2 are individually plugged in, it is possible that if you are not using CV 2 , the input to CV 1 will be automatically duplicated to control CV 1 and 2 by an independent CV signal (See FIG. -
Page 9: Specifications
6. SPECIFICATIONS Power Eurorack system power supply Width 14 HP Depth 22mm Power consumption 38 – 46mA on +12V / 32 – 42mA on -12V Accessories · Eurorack power cable x1 · Mounting screws x4 ACL-E-VCA- 1707 - 1...