4" Phones Jack; Phones Level; Direct Monitor Switch [Onyx Artist 1•2]; Mix Knob [Onyx Producer 2•2] - Mackie ONYX Artist 1-2 Owner's Manual

7. 1/4" Phones Jacks
This 1/4" TRS connector supplies the output to stereo
headphones. The volume is controlled via the phones
knob located just above the phones jack. It is the same
signal that is routed to the line outputs.
The phones output follows standard conventions:
Left channel
Right channel
Ground
Balanced 1/4" Connectors
WARNING: The headphone amp is
loud, and can cause permanent hearing
damage. Even intermediate levels may be
painfully loud with some headphones. BE
CAREFUL! Always turn the phones level control all the
way down before connecting headphones or doing
anything new that may affect the headphone volume.
Then turn it up slowly as you listen carefully.
9
SIG/
OL
DIRECT
MONITOR
MIN MAX
GAIN
LINE/INST
2
HI-Z

8. Phones Level

This knob is used to adjust the volume at the phones
output from minimum to maximum gain. The L/R line
outputs and phones share the same "mix".
WARNING: Yes, we just mentioned this
exact same warning above, but that is how
important this is...the headphone amp is
loud, and can cause permanent hearing
damage. Even intermediate levels may be painfully loud
with some headphones. BE CAREFUL! Always turn this
control all the way down before connecting headphones
or doing anything new that may affect the headphone
volume. Then turn it up slowly as you listen carefully.
Tip
Ring
Sleeve
RING SLEEVE SLEEVE RING TIP
TIP
RING
TIP
SLEEVE
SIG/
OL
MIN MAX
11 8
GAIN
1
USB
HI-Z
MIN MAX
7
9. Direct Monitor Switch [Onyx Artist 1•2]
Engage this switch on the Onyx Artist 1•2 to monitor
the input signals. When engaged, the switch illuminates
green to let you know that you are now monitoring the
levels of the inputs.
The input monitoring occurs in the analog domain,
resulting in zero-latency recording.
10. Mix Knob [Onyx Producer 2•2]
The mix knob adjusts the level of inputs 1/2 and DAW
playback to be delivered to the phones and line outputs.
As an added bonus, this is all at zero-latency!
Knob position (L, C, R):
• Full Left – Input 1/2 = Full Volume
DAW = No Volume
• Center – Input 1/2 and DAW = Equal Volume
• Full Right – Input 1/2 = No Volume
DAW = Full Volume
10 12
SIG/
OL
MIN MAX INPUT DAW
GAIN MIX
2
HI-Z
+48V

11. USB LED

The USB LED will illuminate green when the
computer is powered on and connected successfully
and securely (via USB) to the Onyx USB Interface.
The USB light informs you that the interface is
"enumerated", and in a functional and happy state.
12. MIDI LED [Onyx Producer 2•2]
The MIDI LED will illuminate green to inform you
when data is received at the MIDI input jack of the
Onyx Producer 2•2 interface.
11 8
MIDI USB
MIN MAX
7
Owner's Manual
9