Advertisement
Quick Links
Advertisement
Summary of Contents for Fitvision Technology QCA9531
- Page 1 WIRELESS LAN MODULE QCA9531 USER’S MANUAL...
- Page 2 Interface for serial Flash,DDR1 or DDr2,SDRAM,UART,and GPIOs that can be used for LED controls or other general purpose interface configurations. The QCA9531 PCIE root complex interface can be used to connect to an endpoint such as the Qualcomm Atheros single-chip MAC/BB/radio for dual concurrent WLAN application. The QCA9531 supports 802.11n operations up to 144 Mbps for 20 MHz Likelihood(ML) decoding, Low-...
- Page 3 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 4 This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co‐located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end‐product for any additional compliance requirements required with this module installed IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co‐location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re‐evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: YFXQCA9531”. The grantee's FCC ID can be used only when all FCC compliance requirements are met. Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module.