Package Drawing - Dallas DS5000(T) Manual

NOTES:
1. All voltages are referenced to ground.
2. Maximum operating I
t = 10 ns, V
CLKF IL
3. Idle mode I is measured with all output pins disconnected; XTAL1 driven with t
CC
V = 0.5V; XTAL2 disconnected;
IL
4. Stop mode I is measured with all output pins disconnected;
CC
connected; RST = V
5. Crystal start-up time is the time required to get the mass of the crystal into vibrational motion from
the time that power is first applied to the circuit until the first clock pulse is produced by the on-chip
oscillator. The user should check with the crystal vendor for the worst case spec on this time.

PACKAGE DRAWING

is measured with all output pins disconnected; XTAL1 driven with t
CC
= 0.5V; XTAL2 disconnected;
= PORT0 = V
EA
.
SS
= RST = PORT0 = V
EA
, RST = V
CC SS
EA
18 of 19
.
CC
, t
CLKR
.
= PORT0 = V ; XTAL2 not
CC
DIM
MIN
A IN. 2.080
B IN. 0.680
C IN. 0.290
D IN. 0.090
E IN. 0.030
F IN. 0.145
G IN. 0.016
H IN. 0.590
I IN. 0.009
DS5000(T)
,
CLKR
= 10 ns,
CLKF
INCHES
MAX
2.100
0.700
0.325
0.110
0.060
0.185
0.020
0.610
0.015