Annual maintenance........................25 Maintenance printout........................26 Hand over document ........................28 List of Tables Table 3-1: Delivery contents, in words .....................8 Table 3-2: Delivery contents, in symbols....................9 \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc - 3 -...
Page 4
Teflon spray or another similar lubricant. We hereby confirm that this play equipment has been tested and certified in accordance with the play equipment standard EN 1176. \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc...
Page 5
Because of the properties and characteristics of the components, minor measurement tolerances compared to the indication on the sketches are possible. This concerns all shown measurements except the foundation measurements resp. measurements below upper edge ground level/play area. \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc - 5 -...
Soil class 5 : ground with soil class 3 and 4 with big portion of stones (portion > 30% with bigger diameter of 63 mm grain size). In case of sandy and soft soils, the surface measure of foundations have to be enlarged for about 50%! \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc...
Page 7
Any spare parts which may be required can be obtained directly from your supplier. We hereby confirm that this item of play equipment has been tested and certified in accordance with the play equipment standard EN 1176. \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc - 7 -...
Bolts Rope End Swingers Anker Clamps For Ø 102 mm 100 16 Acorn Nuts 101 8 Threaded Rod M10 x 130 102 16 Washers For M10 Loctite 103 2 Sidewalk fllagstone /provided by the customer! \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc...
In symbols Table 3-2: Delivery contents, in symbols Pos. Quantity Symbol \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc - 9 -...
Page 10
Pos. Quantity Symbol Loctite-Thread locking Adhesive Glue all screws, nuts and sleeves with loctite. (not less than 5 drops !) (except for lock nuts) \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc...
Page 18
(portion > 30% with bigger diameter of 63 mm grain size). In case of sandy and soft soils, the surface measure of foundations have to be enlarged for about 50%! See drawings for details of shortcuts \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc...
• There are no special inspection requirements to be met before the equipment is used for the first time. Retighten bolts • After one week of play, please retighten all bolts again. Later upon respective maintenance. \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc - 19 -...
This equipment should only be assembled, maintained and repaired by persons with the necessary expertise. A copy of the inspection record should be given to the operator, who must confirm receipt. This maintenance instruction is based on the standard “EN 1176-1:2008”. \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc - 19 -...
Maintenance of protective surfaces Surfaces providing fall protection must also be maintained regularly. It is particularly important to maintain the correct level of loose surface material and add more if necessary. \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc...
Page 25
3 years. The steel posts must be excavated down to the concrete foundations and checked for corrosion. Zinc paint should be applied to any corroded areas and scratches. Check ropes for abrasion, replace ropes where coating is damaged down the Steel inlet. \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc - 21 -...
Faults that compromise function should also be repaired immediately. Such faults lower the value of the equipment to the user and encourage malicious vandalism, which may render the equipment less safe. Any damage should also be repaired immediately. \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc...
12.1 The stability of supporting posts, supports, foundations etc. has to be checked. The safety level of the entire system has to be checked after repairs have been carried out or additional system components have been installed or replaced. \\Fileserver\text\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\4585-MD4-01-en-000.doc...
Zinc paint should be applied to corroded areas and scratches. The equipment must be inspected by someone with the necessary expertise in strict compliance with the instructions issued by Huck Seiltechnik GmbH. A copy of the inspection record should be given to the operator, who must confirm receipt.
Huck Seiltechnik GmbH • 35614 Aßlar/Berghausen • Germany seiltechnik@huck.net • www.huck.net 15 Hand over document After the installation of the equipment pass the installation and maintenance documents to the operator. The operator has to receive the hand over documents. The complete filled and signed hand over document should be sent to the supplier.
Need help?
Do you have a question about the 4585-MD4 and is the answer not in the manual?
Questions and answers