Summary of Contents for iPulse iPB6
-
Page 1: Getting Started
Installation Manual Getting Started iPulse Department of Development 2012-09-12 Only applicable to iPB6 Enterprise. For other readers please visit our website www.ipulse.co.za or mail us: iqsuite@ipulse.co.za... - Page 2 Installation Guide Only applicable to iPB6 Enterprise. For other readers please visit our website www.ipulse.co.za or mail us: iqsuite@ipulse.co.za Contents Section 1: iPB6 Installation ..........................3 Device back view ............................4 Complete Wiring Diagram ..........................6 Installation procedures ........................... 7 ©...
- Page 3 The following document will provide a step-by-step process for helping you install your iPB6 biometric unit. Your iPB6 should look similar to the above image. If this is not the case be sure to confirm that you have received the correct device.
- Page 4 This is the back view of your device and its connection diagram. Please note that with your iPB6 Enterprise you will have received an Intelli Relay. This is the relay the iPB6 uses and this connects via the 1-wire port. For further information on these ports please contact us or visit our website.
- Page 5 This is the Wiring diagram for the Intelli Relay. 1-Wire: This is connected to your iPB6 reader. You can see the corresponding ports on the readers wiring diagram Door status: If you are using a lock that provides feedback on its status i.e. open or closed this is where the feedback wiring will be connected to.
- Page 6 Normally Open (N/O) port on the relay. For all the above wiring iPulse suggests you use Mylar cable or cable rated to carry power.
- Page 7 When connecting the reader it is advised to not be doing it with live power cables, If everything is connected you can slide the iPB6 reader onto the back plate lining up the top and bottom pillars correctly. If you have done this the screw holes at the top and bottom should now line up.
Need help?
Do you have a question about the iPB6 and is the answer not in the manual?
Questions and answers