Summary of Contents for NORBAIN VK2-HDA-ENC1
- Page 1 VK2-HDA-ENC1 High definition Analogue encoder Quick Install manual Please read this manual thoroughly before use, and keep it handy for future reference. VK2-HDA-ENC1 Quick install V1.0...
-
Page 2: Warnings And Cautions
* This symbol indicates electrical warnings and cautions. ** This symbol indicates general warnings and cautions. NORBAIN SD reserves the right to make changes to the product and specification of the product from time to time without prior notice. WARNINGS AND CAUTIONS: To reduce the risk of fire or electric shock, do not insert any metallic objects through the ventilation grills or oth- er openings on the equipment. -
Page 3: Important Safeguards
IMPORTANT SAFEGUARDS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer's instruc- tions. - Page 4 Introduction The HD encoder supports multiple analogue video input formats including CVBS. TVI and AHD up to Full HD resolution of 1080P The Encoder will output multiple IP video streams and supports H.264 and MJPEG stream formats. The HD encoder is equipped with RS-485 port for connecting third party PTZ systems.
- Page 5 Installation For the operation of the HD encoder, it is necessary to connect a network cable for data transmission, power connection from supplied power adapter. For its fixation on different locations, please consult with an installer. Overview • Dimension Dimensions Unit: mm •...
- Page 6 • Connectors Item Description Ethernet, RJ-45 port compatible RJ-45 with 10/100Mbps modular Jack 2-pin terminal 12VDC input BNC camera video input 2-pin terminal 12VDC output for BNC camera 3-pin terminal RS485 Connection • Connecting to the RJ-45 Connect a standard RJ-45 cable to the network port of the encoder. Generally a cross-over cable is used for directly connection to PC, while a direct cable is used for connection to a hub.
- Page 7 Resetting to the factory default settings To reset the encoder to the original factory settings, go to the Setup > System > Maintenance web page (described in “System > Maintenance” of User Man- ual) or use the Reset button on the encoder. •...
- Page 8 Network Connection & IP assignment The encoder supports the operation through the network. When a encoder is first connected to the network, it is necessary to allocate an IP address to the device with the “SmartManager” utility on the CD. (Default IP 192.168.30.220) 1) Connect the encoder/device to the network and power up.
- Page 9 50303xxxx...