ASROCK N68-GS4/USB3 FX R2.0 Installation Manual page 12

1.4 Onboard Headers and Connectors 1.4 Onboard Headers and Connectors 1.4 Onboard Headers and Connectors
1.4 Onboard Headers and Connectors 1.4 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
•
Serial ATA2 Connectors
(SATAII_1 (PORT 0.0):
see p.2 or 3, No. 6)
(SATAII_2 (PORT 0.1):
see p.2 or 3, No. 5)
(SATAII_3 (PORT 1.0):
see p.2 or 3, No. 7)
(SATAII_4 (PORT 1.1):
see p.2 or 3, No. 8)
USB 2.0 Headers
(9-pin USB5_6)
(see p.2 or 3 No. 13)
(9-pin USB7_8)
(see p.2 or 3 No. 12)
USB 3.0 Header
(for N68-GS4/USB3 FX R2.0 only)
(19-pin USB3_1_2)
(see p.2 No. 18)
Print Port Header
(25-pin LPT1)
(see p.2 or 3 No. 14)
1 2 1 2 1 2
1 2 1 2
ASRock N68-GS4/USB3 FX R2.0 / N68-GS4 FX R2.0
SATAII_1
SATAII_2
(PORT 0.0)
(PORT 0.1)
SATAII_4
SATAII_3
(PORT 1.1) (PORT 1.0)
USB_PWR
P-
P+
GND
DUMMY
1
GND
P+
P-
USB_PWR
ID
IntA_P_D+
IntA_P_D-
GND
IntA_P_SSTX+
IntA_P_SSTX-
GND
IntA_P_SSRX+
IntA_P_SSRX-
Vbus
1
Vbus
IntA_P_SSRX-
IntA_P_SSRX+
GND
IntA_P_SSTX-
IntA_P_SSTX+
GND
IntA_P_D-
IntA_P_D+
STB#
SPD0
SPD1
SPD2
SLCT
SPD3
PE
SPD4
BUSY
SPD5
ACK# SPD6
SPD7
SLIN#
GND
PINIT#
ERROR#
AFD#
These four Serial ATA2 (SATA2)
connectors support SATA2
or SATA hard disk for internal
storage devices. The current
SATA2 interface allows up to
3.0 Gb/s data transfer rate.
There are two USB 2.0 headers
on this motherboard. Each
USB 2.0 header can support two
USB 2.0 ports.
There is one USB 3.0 header on
this motherboard. This USB 3.0
header can support two USB
3.0 ports.
This is an interface for print
port cable that allows
convenient connection of printer
1
devices.
Motherboard