Advertisement
Advertisement
Table of Contents
Summary of Contents for Plugwise Scan
- Page 1 Scan Presence detection Manual 200.106.110211...
-
Page 2: Before You Start
Before you start • We recommend that you follow this manual carefully; it is essential to take the steps in the correct order. • To be able to use the Scan, you will require a Plugwise network consisting of at least a Stick or Stretch and a Circle+. A Plugwise network can never contain more Scans than 5 times the number of Circles. What this manual explains for the Circle also applies to the 200.106.110211... - Page 3 If the Scan is not found within several minutes, check whether the Plugwise network is operating correctly (refer to ‘Before you start’). If the Stick and the other modules are available in Source and the Scan is still Ì Check whether Source still indicates that the Scan is online. It can...
-
Page 4: Advanced Use
The Scan then sends a ‘Switch on’ Ì Note: remove the battery. As long as the Scan is not assigned to a command in case of a detected movement. If a ‘Switch on’ command network, it will consume more power and the battery will therefore has already been sent, the command will not be sent again. -
Page 5: Technical Details
Detection angle ˚ Depending on position of installation Detection range Dimensions 86 x 80 x 21 Height x width x depth Memory Used for ZigBee firmware Storage capacity kByte updates Service life 100,000 Cycles Programming/deleting ZigBee communication Baud rate kbps O-QPSK 6 channels of the 2.4 GHz Frequency 2400 2483.5 MHz ISM band Bandwidth 5 MHz channel space Reception sensitivity @ 1% per 20-byte packet Transmission power When the Scan sends data wirelessly via the Plugwise ZigBee protocol, a red LED light starts to flash in the casing.
Need help?
Do you have a question about the Scan and is the answer not in the manual?
Questions and answers