Advertisement
Quick Links
Advertisement
Summary of Contents for IPS EggBell
- Page 1 Brief Instruction Manual for EggBell 29/July/2015...
- Page 2 1. Product Introduction & Description 1.1 Brief introduction Accessories： ----EggBell 1 pcs ----Power adapter 1 pcs ----CD with software 1 pcs ----Instruction Manual 1 pcs ----Installation Package 1 pcs ----Bracket 1 pcs 1.2 Product description...
- Page 3 1 WPS Bell Button 2 Reset 10 Speaker 3 PIR 11 Indicator LED for video Recording 4 SD slot 12 Indicator LED for Powe r 5 Came ra Lens 13 Indicator LED for Wifi 6 Microphone Waterproof Case 7 IR cut Anti-tampe r screw hole 8 IR LED battery compartment...
-
Page 4: Installation
17 Powe r port Power s witch Note：When EggBell is switched on, the default mode is ”Smart link” mode; Press once the “WPS” key, it will enter into WPS mode, Press the “WPS” key continuously for 5 seconds, it will enter into AP mode. - Page 5 Warning: Please use the standard AC adapter for the product, in case that EggBell will be damaged. 3、Fix the Bracket Screw on the four corners of the bracket fixed on the door with the accessories in the installation package, and tighten the special anti-tamper screw on the bottom, plug in power source.
- Page 6 1. Download and install the P2P application”EggBell” 2. Search the Application ”EggBell” on application store , and download it on your phone (Android users can get it from “Android Market”，or find and install the APP from the CD attached; iOS users can download on App Store）。...
- Page 7 After connected to Wifi, the bule LED will keep always on (like the picture above), while there will be prompt tone “ding-dong” from the device to tell you configuring successfully. 3、After WiFi Configuration, Click “Direct access” —Add Device—Add a networked device. Three ways to add device, all of them can add EggBell successsfully...
- Page 8 Add automatically: Click “search in the LAN”, the UID of EggBell will be automatically searched, then click Add. Scan mode: Click the button to scan the QR code on EggBell, the red line need to be aligned with the QR code scanner, when h ear a "beep", it tells scanning successfully, the scanner will...
- Page 9 Manually：Click the "Add" icon, manually enter the serial number UID（UID serial number at Then enter in the User Name and the bottom of the label on EggBell, mixed with letters and numbers). Password (They are both “admin” by default). Click the “...
-
Page 10: Function Introduction
3.Function Introduction 3.1Push Function After the door bell added successfully, admit ”Outdoor call-in”, the push function will be available. - Page 11 3.1.1 Push notification when press the bell button When someone press the bell button, EggBell will start recording the video automatically for 20 seconds, and storing the video file in the TF card, at the same time it will push the message to the APP on your phone with ringing tone.
- Page 12 3.2.2 Access to the files saved in the TF card for recording and snapshot The files of snapshot and recording via Pressing button and Staying overtime are stored in the TF card, you can access remotely to these files on APP, just like the files below:...
- Page 13 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the EggBell and is the answer not in the manual?
Questions and answers