ReSound Unite User Manual page 10

Pairing
Note! The following information is intended pri-
marily for your hearing care professional, who in
most cases will complete the tasks that are neces-
sary before the ReSound Unite Remote Control can be used
with your hearing instruments. However, the process is de-
signed to be simple and should be easily accomplished by
almost anyone.
Pairing is the process of setting up an exclusive communication
between your hearing instruments and your ReSound Unite Re-
mote Control. Your hearing care professional can set up pairing
during the fitting of your hearing instruments. Alternatively, you
can follow the below steps to pair your hearing instruments to
ReSound Unite Remote Control:
1. Make sure ReSound Unite Remote Control is using a fresh set
of AAAA batteries and is turned ON. Your hearing instruments
must be off – open the battery door.
2. Press the pairing
ReSound Unite Remote Control (10
on page 7) one time. This will acti-
vate the pairing mode which will be
active for 30 seconds.
18
button on
Searching for hearing
instruments
3. While pairing mode is activated, close the battery doors
of both hearing instruments and make sure they are ON. A
successful pairing will be indicated by an audible melody
played in both hearing instruments, and shown in the remote
control display with an active Program 1 (see below). You are
now ready to use the Remote Control!
Hearing instruments in program 1
19