Advertisement
Quick Links
Advertisement
Summary of Contents for BRIO PartyPro 320A
-
Page 1: User Guide
PartyPro 320A Active Karaoke & PA Speaker User Guide... - Page 2 IMPORTANT! To prevent from Bluetooth transmission lost or bad receiving of wireless microphones, DO NOT use or store the device and its microphones in a magnetic environment. Do NOT drop the device or apply excessive force to it. ...
- Page 3 The Federal Communication Commission Statement This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 4 PART 1. Getting Started 1.1 Package Contents Included in this package are: PARTYPRO 320A Main Speaker and Associated Speaker DC Power Adapter (AC 100-240V/50-60Hz in; DC 19V1.5A out) IR Remote Control Audio Cable (connector 3.5mm-3.5mm) Connecting Audio Wire (for pairing speakers) ...
- Page 5 1.3 Jacks and Buttons on Rear Panel of Main Speaker The rear panel on main speaker 1. Power Jack: DC19V1.5A input. 2. Power On/Off button 3. Battery status LED: LED remains red during charging. LED turns to green once fully charged. An over charge protection is on if LED is blinking.
- Page 6 The LED will blink RED once whenever you press any button to confirm the command received. 1. Power Button Turn on or turn to standby the PARTYPRO 320A during power is ON. Warning: Always switch the main power button to OFF if the speaker is standby over 1 hour for battery volume saving.
- Page 7 Note: The default input is Bluetooth. The Bluetooth will pair the device which had been paired before automatically. The Bluetooth will enter manual pairing mode after 15 seconds if paired device is not found. 3. Music Volume Adjustment Increases or decreases the music volume from 0-15 range.
- Page 8 8. REC (Recording) For KM210 only. 9. SET For KM210 only.
- Page 9 PART 2. Using PARTYPRO 320A 1.1 Basic Operation 1. Turn the Bluetooth of your source device ON if you are using Bluetooth connection. 2. Turn ON the power button (or from remote control if the main speaker is standby), and the speaker will enter the automatic pairing mode of Bluetooth.
- Page 10 3.2 Advanced Features PARTYPRO 320A uses remote control as the command inputs. Volume Control Volumes of music and microphone can be adjusted separately. To prevent the bad sound quality caused by speaker overload, always tune your input source to be under 80% of volume.
- Page 11 PART 3. Certifications, Liability, and Trademarks Certifications This device is CE and FCC certified. Limited Liability Neither the manufacturer nor the dealer will be responsible for any accidental damage including bodily injury resulting from any misuse or improper operation by any user. Trademarks Karaoke Master is a registered trademark of XCUBE Technology Inc.
Need help?
Do you have a question about the PartyPro 320A and is the answer not in the manual?
Questions and answers