Table of Contents
Advertisement
Connect Input and Output Devices
1.
Connect the audio source devices (such as CD
changers or players, DVD changers or players, or
tape players) you want included in the system to the
Audio In jacks.
2.
Connect amplifiers or amplified speakers as needed
to the Audio Out jacks.
NOTE:
the worksheet provided in Table 2-1 to plan your routes.
Connect to the Network and Power
1.
If you are using an Ethernet connection for Audio
Matrix Switch, plug the data cable from the home
network connection into the Audio Matrix Switch RJ-
45 port (labeled "Ethernet") and the network port in
your wall or at the network hub or switch.
2.
Connect the power cord provided to the back of the
Audio Matrix Switch and to the power outlet. Once
the power cord is connected, the Audio Matrix Switch
should power up.
Set Up Logical Connections
Physical and logical connections are required in order to
control, navigate, and use the Audio Matrix Switch as
designed.
Thus far you have set up the physical connections for the
Control4 Audio Matrix Switch. To complete the logical
setup, trained installers must use a PC connected to the
home network with Control4 Composer software installed.
If you are a trained Control4 installer, refer to the Control4
Composer Pro User Guide.
If you are not sure which jacks to use, try using
11
Advertisement
Table of Contents
