DualLite UFO-3AW Installation Instructions

IMPORTANT SAFEGUARDS

Installation INSTRUCTIONS -
READ AND FOLLOW ALL SAFETY
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. To prevent high voltage from being present on red & yellow output leads prior to installation, inverter
connector must be open. Do not join inverter connections until installation is complete and AC power is
supplied to the emergency ballast.
1. To prevent high voltage from being present on red & yellow output leads prior to installation,
2. This product is for use with most 32 W through 40 W T8, T10, or T12 single pin or bipin fluorescent lamps,
inverter connector must be open. Do not join inverter connector until installation is complete and
including energy saving, circline, U-shaped and rapid-start (4-pin) long compact fluorescent lamps.
AC power is supplied to the emergency ballast.
2. This product is for use with 16 W through 40 W (2ft - 4ft) T8 and T12 single pin or bipin for one
3. Make sure all connections are in accordance with the National Electrical Code and any local regulations.
or two lamp emergency mode operation, instant start and rapid start; 40 W through 215 W (5ft -
4. To reduce the risk of electrical shock, disconnect both normal and emergency power supplies and inverter
8ft) T8 and T12 single pin or bipin for one lamp emergency mode operation, instant start and
connector of the emergency ballast before servicing.
rapid start; and 16 W through 31 W U-Bend T8 bipin for one or two lamp emergency mode
5. This emergency ballast is for factory or field installation in either the ballast channel or on top of the fixture.
Operation, instant start and rapid start flourescent lamp fixure
6. This product is suitable for damp locations where the ambient temperature is 0°C minimum, +55°C
3. Make sure all connections are in accordance with the National Electrical Code and any local
maximum. Product is not suitable for heated air outlets and wet or hazardous locations.
regulations.
7. An unswitched AC power source is required (120 through 277 VAC, 60 Hz).
4. To reduce the risk of electric shock, disconnect both normal and emergency power supplies and
8. Do not install near gas or electric heater.
inverter connector of the emergency ballast before servicing.
9. Do not attempt to service the battery. A sealed, no-maintenance battery is used that is not field replaceable.
5. This emergency ballast is for factory or field installation in either the ballast channel or on top of
Contact the manufacturer for information on service.
the fixture.
10. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
6. This product is suitable for damp locations where the ambient temperature is 0°C minimum,
11. Do not use this product for other than intended use.
+50°C maximum. Product is also suitable for installation in sealed and gasketed fixtures. Product
12. Servicing should be performed by qualified service personnel.
is not suitable for heated air outlets and wet or hazardous locations.
7. An unswitched AC power source is required (120 through 277 VAC, 50/60 Hz).
CAUTION: Verify that all replacement lamp types marked on the installed luminaire are also identified as suitable for use
8. Do not install near gas or electric heaters.
9. Do not attempt to service the battery. A sealed, no-maintenance battery is used that is not field
replaceable. Contact the manufacturer for information on service.
10. The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition.
11. Do not use this product for other than intended use.
12. Servicing should be performed by qualified service personnel.
CAUTION: Verify that all replacement lamp types marked on the installed luminaire are also identified
WARNING - This product contains chemicals known to the State of California to cause cancer,
2
as suitable for use with this inverter/charger pack.
birth defects, and/or other reproductive harm. Thoroughly wash hands after installing, cleaning, or
B
WARNING
NO LISTING
INSTALLATION INSTRUCTIONS
UFO-6W
When using electrical equipment, basic safety precautions should
always be followed including the following.
! IMPORTANT SAFEGUARDS !
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
REV DATE
B
11.OCT.2010
C otherwise touching this product.
SAVE THESE INSTRUCTIONS 16.JUN.2016
CONTAINS NICKEL-CADMIUM
RECHARGEABLE BATTERY.
MUST BE RECYCLED OR
56B5
EMERGENCY EXIT FIXTURE
DISPOSED OF PROPERLY.
LIGHTING
EQUIPMENT
– This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
56B5 LISTING 57B9 LISTING
with this inverter/charger pack.
1
RECORD DESN CHCK
EC-091027001 MDB SGH
EC-160616002 JEB JEB
B
57B9
UFO-3AW
Emergency Lighting Fluorescent Battery Pack
Auto Select
Ni - Cd